2002 Mercury Mountaineer Logo

Related Topics:

manny Posted on Aug 01, 2012

Tramission problem(od lights staying on)

I got a new tranmission but the light still come on

1 Answer

A

Anonymous

Don't use it,take it back & have the issue diagnosed

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My overdrive light comes on and stays on

OD'd on OD? sigh.
OD is a tranny function. (top gear, overdriven ratio)
the lamp can also show failures.... (old cars, where is this lamp>?)
all this is in the operators guide, in the glove box.
read the lamp and its modes of operation. and warnings.
07 is here, my be same,,, probably
http://justgivemethedamnmanual.com/jeep/jeep-commander-owners-manuals/

page 134 , tow-haul switch set wrong? ERS option ! only.
does car have the EVICs display that gives message warnings?
like transmission overheated, etc.?
OD operation is complex. 4s or 5speed.
it can drop out with too cold and engine, or in 4wd.
speed, load and other conditions. including
Is the Check Engine lamp glowing , running? if yes scan it.
as this lamp also reports transmission errors. pg 176.
is your car 2wd or 4wd? ?
conditions for OD
in DRIVE
normal engine/trans temperatures.
above 30mph.
tow-haul , switch off.
out door temps not too cold. page 260
advice: What is the CEL doing and are all fuses good.
1: this car uses, CAN buss, a car digital network.
it can have errors, and if the OD function is acting up
the book says, do the CAN diagnostics to see if there are errors
from the Display system called CLuster, and the BCM/PCM or tranny functions.
there are 2 tranmissions ( RFE or NAG?)and 3 engines and diff, 2wd/4wd systems options. non of which were stated.
nor exactly where this light is? they never mention it in the opr guide.


0helpful
1answer

Over Drive Off and Check Engine lights

well check engine light is most likely a sensor and needs to be scanned and that could caose the overdrive problem
0helpful
1answer

Should my od button be lit in the off position

It should not be lit when the togle button is off. If you press it again does the light stay on?
It could be an issue with the dash light itself or the OD switch may not be working.
0helpful
1answer
2helpful
1answer

Transmission OD light stays on

My Mazda MPV 1997 OD light flashes and engine light is on
1helpful
1answer
1helpful
1answer

Od light blinking and tranmission shifting hard

this is the first sign your tranny is shot or try changing the filter if your tranny filter is clogged it will act the same as you are saying
0helpful
1answer

How to replace a tramission seal

Try “autozone.com” or your local library for diagrams and step by step instructions.
0helpful
1answer

Engine light stays on a 97 olds achieva sl

Engine light stays on, low coolant light stays on , recently had a plastic housing replaced that was leaking, it was linked to thermostat, tranmission coolant,heater ect. Had the thermostat replaced also. Level of coolant is fine, does't overheat anymore, but now the starter wants to spin a couple of times and then it starts. The car has no rust, would like to hang on to it
Not finding what you are looking for?

58 views

Ask a Question

Usually answered in minutes!

Top Mercury Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...