Question about 2005 Chevrolet Trailblazer Ext

1 Answer

How to change bulb on drivers side low beam head light

How do you change the low beam bulb in headlight of 2005 chevy trailblazer?

Posted by on

  • 4 more comments 
  • Anonymous Mar 16, 2014

    2000 chevy prizm where right front low beam has been going out intermittently (off then on again a day or two later) for last week, but today both low beams went out. High beams are still on. Bulb or other issue?

  • Anonymous Mar 19, 2014

    Low beam lights dont work but highs do

  • Anonymous Mar 24, 2014

    where do you connect the negative wire from the wire harness to low beam wire?

  • Anonymous Mar 25, 2014

    I have high beam but no low beam. And we've changed the bulbs still no lights

  • Anonymous Mar 26, 2014

    no low beam headlights

  • Anonymous Apr 01, 2014

    no low beam headlights working

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 75 Answers

My niece has a jimmy, they should be the same. The inside should be the high beam, the outside the low, DO NOT TOUCH THE GLASS ON NEW BULBS! Oil will cook on them and pop them! Both come off the same way. Take off the big rubber thing. They are soft but over hard plastic. Just pull them off. If you have trouble, you can flip the little wire clips that hold the headlight housing in place, this will give you room to see the rubber caps enough to figure them out better. The bulb assembly rotates CCW counter clockwise, and should slip out easily. Take the wires and plug off. it should be obvious how it pulls off. Snap the new bulb into the wires without touching the glass part. Gently replace in backwards order as you removed it. Put the rubber caps on, they keep water off the bulbs. It will break them!

The passenger side was harder for me. I had to take the air cleaner off, the whole cover and filter.You should be able to see or feel the same type caps, The low beam outside, High beam inside. The same 2 wire clips are there to release the housing. Everything pretty much goes the same, other than the air cleaner has to be removed and replaced. And make sure the rubber cap is replaced! Good Luck and good motoring!

Posted on Dec 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Head light have low but when using high does not work just on one side drivers side


HELP! headlight not working even after change - Nissan Forums ...

www.nissanclub.com/...nissan.../302674-help-headlight-not-working-eve...

Apr 1, 2010 - 13 posts - ‎6 authors
My passenger side low beam headlight recently went off on me. ... I've changed the bulb again, and changed the fuse just in case, but .... My driver side headlight wire got loose so when i hit a bump at night if would flicker. ... When you notice one side not working (Low or High beam) it could be the module. Headlight replacement
15 posts
Jan 22, 2009
Low beams don't work but High's do
8 posts
Mar 20, 2005
More results from www.nissanclub.com

Dec 20, 2015 | 2004 Nissan Sentra

1 Answer

How do you change the low beam light on 2006 chevy trailblazer?


For the drivers side, reach down by your alternator and over behind the headlight. You'll feel a 3" round rubber boot. Slip this off and now you can remove the light bulb.

Passengers- Remove the top of the air cleaner, at that point you'll have complete access to the rubber boot and bulb.

Mar 14, 2011 | 2006 Chevrolet Trailblazer

1 Answer

How do you replace a low beam headlight bulb in a 2006 Chevy Trailblazer?


Drivers side- reach hand behind headlight and remove the rubber cover, then turn and remove bulb.

Passenger side- remove air cleaner top and move the air cleaner out of the way. Now you have access to the rubber cover to replace the bulb

Dec 13, 2010 | 2006 Chevrolet Trailblazer Ext

1 Answer

I have no low beam headlights. The high beams work and I have changed the switch and bulbs and checked the fuses. what next


Check the connectors that go to the headlight bulbs to see if they are burned or melted. Low beam lights are on longer than high beams. The heat buildup around the connectors normally melts them.

Sep 27, 2010 | 2005 Chevrolet Trailblazer Ext

1 Answer

Headlight replacement o5 trailblazern 200


Hi El, Since it's on the passenger side you'll need to remove the air filter housing & filter to get to the housing for the bulbs. Right behind that bulb housing there are two rubber coated caps (those caps are where the bulbs are located) that you'll need to remove. They can be tough to remove so it should be ok to use a flat head screwdriver to GENTLY pry the caps. Just make sure you are GENTLE with it and once it is loose use your hand to turn it counterclockwise about 1/4 turn. Gently pull it out then unplug the wire harness to it. **** IMPORTANT*** Like most headlight bulbs, DO NOT TOUCH THE NEW BULB WITH YOUR BARE HANDS. Halogens are ruined by our natural oils and it will make your new bulb burn out extra fast. Also: The outside bulb should be the LOW BEAM and the inside should be the HIGH BEAM. Let me know if you have any other questions and I'll be happy to help.

Apr 23, 2010 | 2005 Chevrolet TrailBlazer

1 Answer

How do i change the lowbeam headlight


There are two clips on the head light assy under the hood that you pull up and the head light comes out. you have to change the bulb in the head light because low and high beam lights are the same bulb.

Feb 07, 2010 | 2005 Chevrolet TrailBlazer

1 Answer

Head light bulb replacement 2003 chevy trailblazer


Simple! (I have the same model as well) Pop off the front chevy grill - it's held on with spring clips. Then look at the headlight assembly - there are 2 slide clips on either side, near the top - they have a tab that is bent forward - lift them UP. It may take a little force as they are usually stiff. The headlight assembly can then be pulled off the car, and the bulbs replaced.

Apr 18, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

Replace a headlight in 2005 chevrolet trailblazer It is the low beam light that is on the passager side.


Purchase a pair of bulbs (30.00). Start by removing the plastic trim with the Chevy emblem, pry off with a screw driver. There are two tabs that hold the head light assembly in place. Pull both up and the assembly falls forward. A quarter turn releases the bulb housing. Change bulb and reassemble in reverse order.

Apr 07, 2009 | 2005 Chevrolet TrailBlazer

1 Answer

Head light burned out


just did 06 open hood look at top of light  should be 2 L shaped pins turn  and lift out whole light will lift out then change bulb no tools needed 06

Jan 07, 2009 | 2005 Chevrolet TrailBlazer

Not finding what you are looking for?
Cars & Trucks Logo

576 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...