Question about 2002 Volkswagen Jetta TDI

2 Answers

Anti slip light is on. How to turn it off? What could be the pr

What else could cause this light to come on?

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers


Posted on Dec 18, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 38 Answers

Will need to be plugged in on diagnostic equipment but probably gonna be caused by a fault sensor on one of the wheel hubs as fairly common then will need to have fault cleared with same equipment.

Posted on Dec 15, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Asr light on wont rev up goes off may run a wweek no problem then act (ugly) again

if your ASR light is on, then either you are experiencing wheel-spin (even a small amount will cause it to flash), or you might have pressed the ASR button to turn it off (it will be on constantly).

When on and slipping; engine revs are limited by computer to maintain control. Until it resets. This feature may be disabled by pressing ASR or "anti skid" button... not recommended unless prepared for wheel slippage.

Sounds like it is doing its job? The rev up shutting down will not hurt your motor... It's the trade off for uncontrolled slipping being controlled by computer..

Jan 03, 2016 | Cars & Trucks

2 Answers

Abs vdc and slip light

I think a trip to the nissan dealer may be needed. The Slip and VDC sytem is tied into the anti-lock brake system. Could be as simple as a vacuum leak or a bad check valve at the brake booster, or the ABS system could be malfunctioning.

OBD2Guide com Technical service for OBD2 auto scan tools

Feb 21, 2014 | Cars & Trucks

1 Answer

Location of asr anti slip

ASR light on, mostly caused by a brake switch,

Jan 28, 2014 | 1992 Mercedes-Benz E-Class

1 Answer

Serpentine belt

sounds like belt tensioner might be worn out.check to see if belt has tension after u install

Sep 29, 2013 | 1998 Ford Escort

1 Answer

2009 dodge truck lights staying on on dash, brake,abs ,esp,anti slip light are all on. How to clear?

Have someone scan the body computer for trouble codes.
Once the problem is fixed and the codes are erased, the lights should stay off.

Feb 25, 2013 | 2009 Dodge Ram Pickup 1500

1 Answer

Anti lock brake light keeps coming on and then the low traction light comes on and the brakes seem to be slipping

sounds like a ABS sensor has failed. Please have it checked soon,didnt like when you said brakes are slipping,this could be very dangerous.....hope this helps and good luck....Please rate my post and thank you ahead of time.

Aug 16, 2012 | 2003 Pontiac Bonneville

1 Answer

I have a 2007 Jeep Compass Limited 4x4 and the ABS, 4WD, ESP BAS and Anti-Slip lights are all on at the same time. They came on while driving and have went off then back on a few times and now they just...

The lights are being turned on by your BCM or Body Control Module. It's located under the driver's side knee bolster, but it will probably have to be taken to the Dealership to hook up their DRB III to ascertain as to why the BCM is turning on all of your lights.

"00 Buck"

Nov 06, 2009 | 2009 Jeep Compass

1 Answer

Is the RPM gauge and the transmission connected for a 2001 chevy impala?The Anti light brakes and traction control light turn on. Now the transmission does seem to shift properly and the RPM gauge moves.

Anti lock brakes and traction controls will light if there is too much tire pressure differential. That mean a low tire turns more rpm in a mile than a full tire so it constantly thinks it is slipping in either /both taking off or braking... Tire pressure is important. Check it!

Aug 27, 2009 | Chevrolet Impala Cars & Trucks

1 Answer

Car suddenly died

This most likely is not the cause of the car failing unless it is caused by a bigger electrical problem.

The yellow triangle with an "!" point in the center is the ASR/EDL indicator, Anti Slip Regulator. If it flashes while driving it just means the anti-slip has been activated. It will stay lit if the system has been manually switched off or if it is malfunctioning. A malfunction would not affect the car's running other than you have no anti slip function. This is an option.

Apr 10, 2009 | 2000 Volkswagen Beetle

Not finding what you are looking for?
2002 Volkswagen Jetta TDI Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

81294 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides