Question about 2003 Pontiac Vibe

Open Question

Cruise control on 2003 Pontiac Vibe won't engage

Recently you responded to a problem of mine and I did what you said with the brake pedal. After looking under dash for the switch you noted, the only thing I seen was one that the the brake pedal (arm) pushes against when you let off the break. I also checked all fuses that had anything to do with the Cruise control (OK) and the lines coming out of the cruise control actuator appear to be fine. Do you have any other suggestions for me to fix my problem?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 2002 Pontiac Grand Am Cruise Control

Try blowing trash out of the unit attached to the steering wheel.Sometimes,this'll eliminate the issue.If not,U may have to replace the unit.

Posted on Jul 24, 2008

Ad
ovs5
  • 38 Answers

SOURCE: Cruise control will not engage

Hi, May be worth checking the switch at the brake pedal could just be that its sticking slightly, if you try the cruise control out again just flick foot under brake pedal and lift it up to make sure not holding any pressure on switch.

Posted on Dec 11, 2008

  • 30 Answers

SOURCE: "Sticky" accelerator

no, that's not likely the throttle body. start by looking at the throttle body though, if there are cables going to it that control it, follow the cables back, one should go to the firewall, and one should go to a little black box. that box is you're cruise control unit. chances are that is what's causing the problem (try a salvage yard, they're cheaper than a dealer). however if there is an electric motor controlling the throttle, you should take the car to a shop to have it fixed.

Posted on Jan 24, 2009

  • 462 Answers

SOURCE: installation of cruise for Pontiac G5

THE DEALER WOULD HAVE TO PROGRAM THE BODY CONTROL MODULE TO RECOGNIZE THE ADDED CRUISE CONTROL.

Posted on Jul 25, 2009

  • 33 Answers

SOURCE: The cruise control does not engage.

there is not a fuse but there is some vaccuum lines. if you are faceing your car with the hood open, look at the right side of the enging bay. near the washer and kind of under the master cyilinder there should be a metal can looking thing with some rubber or plastic lines coming off. replace any vaccuum lines that are worn and your CC should come back.

Posted on Aug 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 oldsmobile alero v6 -- cruise control stopped working...The cruise on/of button lights up, the green light cruise indicator comes on in the dash panel, but cruise control does not engage when CST SET...


Try checking the small switch at the top of the brake pedal. There may be two one for brake lights and one for the cruise control. To ascertain what is what, pull one wire off and see if brake lights work. If not, then the other switch controls the cruise control disconnect and engage..I you have a DC test light check to see if power is on on both side of the switch with brake pedal up. If so, depress pedal and check power on the other side there should be none, if there is the switch is defective.

Aug 02, 2017 | Cars & Trucks

1 Answer

Cruise control lights go on but cruise won't engage


Is you brake light working properly?

Feb 04, 2013 | Cars & Trucks

1 Answer

Cruise control will not engage consistently


check the brake switch on the upper arm of the brake pedal, if its bad your cruise control won't work because the truck thinks your pushing the brake pedal. I had the same problem in mine, it's a $30 part that takes about a half hour to fix

Jan 30, 2013 | 2008 GMC Sierra 1500

2 Answers

How to fix cruise control


Cruise controls can cease to engage if the clutch or brake light cruise switch are out of adjustment. If this happens, try placing you foot under the clutch pedal (if equipped) and lift up on it (toward you) and hold it while engaging the cruise. If it now works, it will likely cut out when you remove your foot from under the pedal. Check the brake pedal in an identical fashion. Adjusting the switch at the pedals can often solve he problem. Some vehicles (Honda, Acura, Ford, to name a few) have a plastic insert that mounts in the pedal arm which presses against the switch. These can become brittle and fracture into pieces. My Acura has little pieces of blue plastic on the floorboard around the brake pedal one afternoon and I noticed the cruise didn't work. It was the pieces of the insert that had come to pieces preventing the cruise from coming on. I replaced the insert and no more problem with the cruise.

Mar 10, 2012 | 2003 GMC Sierra 2500HD

1 Answer

2003 Pontiac Vibe Cruise Control Problem


This is normal. Cruise control is supposed to cut out if driving conditions drastically change.

Apr 11, 2010 | 2003 Pontiac Vibe

1 Answer

Cruise control will not engage


Could be an open fuse or defective speed sensor

Aug 28, 2017 | 2003 Pontiac Vibe

2 Answers

Cruise control will not stay engaged


When I try to engage the cruise control, the dash light flashes, but it doesn't stay on.

Mar 28, 2009 | 2003 Ford Explorer Sport Trac

1 Answer

Cruise control will not engage


Hi, May be worth checking the switch at the brake pedal could just be that its sticking slightly, if you try the cruise control out again just flick foot under brake pedal and lift it up to make sure not holding any pressure on switch.

Dec 11, 2008 | 2003 Pontiac Vibe

2 Answers

Cruise Control


make sure brake lights are working,if working brakepedal switch fine.it is most likley the cruise control cut out switch.blue and white switch on brake pedal.

Oct 20, 2008 | 2000 Ford Expedition

Not finding what you are looking for?
2003 Pontiac Vibe Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...