Question about 2004 GMC Yukon

2 Answers

I have a 2004 gmc yukon when I try to start it it just cant kick over, the battery is fine it just cant get the final kick to start

Posted by on

  • 6 more comments 
  • yletarte Dec 15, 2008

    I guess so.......I turn the key the enigine turns over but its like it cant get enough power to start it just whines

  • yletarte Dec 15, 2008

    the enigine is trying to start but sounds like not getting enough gas I think

  • yletarte Dec 15, 2008

    would this happen graduly or happen suddenly I have never had a problem before but with the shortage we had here recently I did run under 1/4 tank frequently

  • yletarte Dec 15, 2008

    Thank you so much for your help :-)

  • yadayada
    yadayada May 11, 2010

    there is a point where it works and when it quits, I guess that is suddenly.

  • yadayada
    yadayada May 11, 2010

    U will need to have the fuel pump tested, if u are stuck have it towed or get someone who has the skills to check the fuel pressure, the pump is located in the fuel tank, they are prone to fail around 100,000 miles or if u run the tank below 1/4 on a regular basis, that overheats the pump, it is cooled by the gas it sits in.

  • yadayada
    yadayada May 11, 2010

    Not enough info, sorry don't know hat you mean by the way u describe the condition, the starter either turns the engine or it doesn't.

  • yadayada
    yadayada May 11, 2010

    U mean the starter does not turn the engine over?


2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

And also check your fuel pressure sensor fuel pump crank sensor cam sensor

Posted on Jul 27, 2014

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,114 Answers

Check the "knock sensors" under the intake manifold, notorious for water damage. Need to check the fuel pressure as well. Fuel pump could be bad. Has the "Service Engine Soon" been on at all? It's all a "**** shoot" without the proper testing equipment.

Posted on Jul 06, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What are the symptoms of a defective pickup coil in a 1996 GMC Yukon,5.7L Vortec?

check the ignition timing on the crank pulley. Run the fault codes to check for sensor fault.

Aug 27, 2014 | 1996 GMC Yukon

1 Answer

2004 yukon xl

Check battery charge, starter in good conditions, ignition switch, spark and fuel pressure and finally, some aftermark or antitheft systrem activated.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Dec 19, 2011 | 2004 GMC Yukon

1 Answer

2004 gmc yukon xl denali front a/c blower not working

ac on a 2005 gmc yukon not blowing and cant here compressor the rear ac of the truck is working fine, are there any fuses i can check?

Jun 28, 2010 | 2005 GMC Yukon Xl Denali

2 Answers

I have a 2004 GMC Yukon with auto climate control. The front a/c is working but the fan will not come on. The rear a/s works fine. Checked fuses, they are all good. Any suggestions?

It's most likely your blower motor control module. Easy fix! Remove the kick plate under the glove compartment and the module is right next to your blower motor - remove the two screws and it will drop right out. Disconnect the wire harness (2 wires) and replace. Good luck!

Jul 28, 2009 | 2003 GMC Yukon

1 Answer

2004 GMC Yukon won't start if less than 1/4 tank of gas

sending unit for gas gauge is not correct

Jul 06, 2009 | 2004 GMC Yukon

7 Answers

My instrument cluster not working on 04 gmc yukon i checked fuses and harness for cuts or frays

disconnect ur positive battery cable. make sure not to set alarm with remote. let set for about 5 minutes, this happened to my 2003 gmc yukon xl and it actually worked

Mar 15, 2009 | 2004 GMC Yukon

3 Answers

Step on gas and engine studders

its the fuel pump, i have 2001 GMC yukon and thats what it did, it would start an run, idle just fine, but put it on ther computer to test it, it showed lean on both banks,meaning that the fuel pump was going out, was loosing pressure, i got a pump for 256.00 had a frind help me change it, it runs just fine,,

Nov 19, 2008 | 1999 GMC Yukon

Not finding what you are looking for?
2004 GMC Yukon Logo

Related Topics:

297 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

71162 Answers


Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides