Question about 2007 Chevrolet Silverado 2500HD

4 Answers

Location of block heater cord on my 2003 chevy silverado

Thats it

Posted by on

Ad

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

MIne was on the passenger side inside the wire loom next to the shock. You can get to it through the fender well. It just looked like a ball of tape and only the plug itself was exposed with the rest of it doubled back on itself inside the loom. It was actually long enough to stick out of the front of the truck.

Posted on Jan 18, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 1 Answer

Information on the use and location of the block heater termed "Engine Coolant Heater" is found on page 2-24 of the 2003 Owner's Manual:
"To Use the Engine Coolant Heater"....
1. blah.. blah .. blah
2. "Open the hood and unwrap the elcetrical cord. The cord is located on the driver's side of the engine compartment, near the power steering fluid reservoir. If you have a diesel engine, refer to diesel supplement for location.
3. blah..blah..blah

If you haven't found it yet, don't be surprised it's not there. By the spring of 2003, certain parts weren't installed on my Silverado, like the lock on the tire jack access hole on the rear bumper, even though it was included in a GM print out of the equipment included on my specific truck (I discovered that in time and even though GM claimed it was a $20 option, I insisted the dealer install it free - which they did). And somewhere along the line, GM dropped the underhood light that was included even on my 2000 base truck. Along with the 2nd accessory power outlet on the dashboard. GM was slowly stripping parts from 2000 on up. Excessive warranty costs may have been the reason. But that's another story.

Hope my answer helped.

Mark

Posted on Jan 10, 2009

  • Mark
    Mark Jan 10, 2009

    I searched everywhere on my 2003, a nicely optioned Silverado LS, both sides, hi and low. There's no block heater! But my base 2000 truck did! GM ships a truck to Canada without a block heater! And yet RIck Wagoner earned $15.7 million with plants closing and an economy tanking! Maybe I should ask him how come GM was shedding parts and still ended up needing a bailout of taxpayer money!

×

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Found my block heater cord for my 2003 Silverado nicely taped up on the driver side underneath by front axle.

Posted on Nov 19, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 116 Answers

Look under yhr hood for a balled up cord on passenger sde and look in behind grill

Posted on Dec 15, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to pass smoke check for these fail problem, thermostatic air cleaner, air injection, and fillpipe retrictor


Thermostatic air cleaner that that tube that goes to the air cleaner,you will need that,it NOT expensive,air injection thats the smog pump is the hose connected? Is the belt connected to it, It needs to be working not missing any parts of it, like the belt for the air injection or the hose that is attatched to it. As for fill pipe inspection that is NO longer a inspection it is no longer tested,That was when leaded gas was available.

Mar 08, 2012 | Cars & Trucks

1 Answer

Bmw 523i 1999 model asc light on and stays on when driving ABS working normally


The fact that the ABS is OK means that the wheel speed sensors are OK. The sensors are the part of the system that get the most abuse, so it is good to eliminate them as suspects.
On a 1999, I think that you have a mechanical (cable-driven) throttle rather than drive-by-wire throttle. If so, the ASC has its own throttle just outboard of the regular throttle. If you don't see it, follow the air tube up from the air filter to the intake manifold. The throttle(s) are attached to the center of the intake manifold at the end of that air tube..
If your ASC has its own throttle, that means that you have an actuator and a little throttle cable running from the actuator to the ASC throttle. Since that is a moving part, it is subject to wear, dirt, and corrosion that interfere with motion. That makes this system the second suspect after wheel sensors. Check that cable for fraying and a full range of motion as it pulls the lever on its throttle. Unplug the control wire to the actuator and make sure that the connections are clean and tight.
I recently had an ASC light that turned out to be a hose clamp that was installed improperly and was interfering with the motion of the throttle arm on the ASC throttle.

Sep 22, 2011 | 2001 BMW 5 Series

2 Answers

What is the small radiator/cooler that sits in front of the main radiator on a 2002 Hyundia Sonata CDX and what is its function


If its automatic then its your tranmission oil cooler.If you have air con then that could be for that.Check to see if the pipes going to the rad run back to the gearbox.if not then its your air con rad.hope that was helpfull.

Aug 24, 2011 | Hyundai Sonata Cars & Trucks

1 Answer

How do I find the ground for my 2002 Grand Cherokee back lights? The lights and blinkers only work when they want to.


One of the things that you will want to check is the bulbs, and not necessarily the filament that is in them. My 03 Ram had the same issue and what was happening is that the conectors that are on the bulb housing were burnt in two and they would work when they wanted to. Chrysler replaced the entire bulb housing/board that the bulbs plugged in to and replaced the wiring and the issue was still there. I happened to double check their work to see if they really replaced what they said they did and when checking, I found that the bulbs were not replaced and that was the entire issue.
If you have a tow package and the wiring harness that will allow you to plug a trailer up, I would recommend checking that out as there is a box that the wires run through and sometimes the box will go bad. If there is a box there then there wil also be a ground wire that ties into the frame or subframe and sometimes they will lose connectirvity, had that happen on an Isuzu Rodeo. Check the easy stuff first as it is usually the issue and that will save you a lot of time. The las thing I would do is to trace the wires.


I hope that you have found this information useful as that is my goal.

Jan 16, 2011 | 2002 Jeep Grand Cherokee

1 Answer

Terrible vibration and noise from the exhaust pipe. I was told that when Braun does the drop floor that they remove the weights from the exhaust pipe and that there is no fix for the vibration and...


There are custom exhausts that can fix that, but they are expensive, will cause a loss of power and the fix will not be total - you will still feel some minor vibrations.

Jan 26, 2010 | 2007 Toyota Sienna

1 Answer

MY CAM BELT IS BAD IS THAT BACK THE GEAR ON THE


thats the balancer shaft gear, its LOCKED UP??? thats bad, never had that happen. a shop that does a lot of HONDA work should look at that for you, the engine may need to come out. sorry for the bad news ; (

Oct 20, 2009 | 1996 Honda Accord

1 Answer

Subaru forester 1997


All around good car with great ground clearance and use-ability. Be aware of used ones that have high miles due to the fact that the 2.5 that was used is prone to head gasket failure. Make Certain that when puchacing one, that records are included that illustrate that both head gaskets have been replaced and that new ones meeting updated OEM standards where used. Run Subaru coolant conditioner and service regularly and this car will run 200k+

Oct 06, 2009 | 1998 Subaru Forester

1 Answer

Toyota 1988 camry


Egr Valve is usually attached to plenum with a tube that runs to exhaust minifold. If you dont know what those things are then. Find the black tube that runs from the front of the car to the front of the motor. there should be a big square box where you air filter goes in the middle of that tube. Well where that tube connect on the front of the motor. That is called the throttle body. the big block of aluminum is called the plenum. Bolted to that plenum is going to be a space ship looking thing that has one rubber hose a wireing plug that plugs into it and a long tube that is attached to the bottom that goes down behind the motor to your exhaust. There should be 2 or three nuts or bolts that hold it in place. Sorry if I overexplained this but I do not know how much you know about the car......Good luck!

Dec 26, 2008 | 1988 Toyota Camry

3 Answers

REPLACING A HEADLIGHT BULB 1999 SAAB 9-3


http://www.ehow.com/video_2630_replace-car-headlight.html

that might help

or

1st remove the plastic cap that covers the back of the bulb

then just twist the rest off to the right..something like that..im gonna work on it tommorow

Jul 16, 2008 | 1999 Saab 9-5

1 Answer

Gas to diesel


honestly, i am not sure about that. but i know that there are tranis that do hook up. so if that is what you heard that i would believe it.

good luck

Jun 20, 2008 | 1994 Toyota Land Cruiser

Not finding what you are looking for?
2007 Chevrolet Silverado 2500HD Logo

4,608 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...