Question about 1999 Chevrolet Blazer

1 Answer

Shifting when warm

I have a 97 s10 blazer when i drive it when cold it shifts fine, when tras warms up, when i go to take off it takes off in 1 gear but when it shifts in to 2gear it shifts hard and check light comes on and then it shifts in to 3 gear but wont shift in to over drive. when i stop and go to take off it takes off in 2gear and wont go in to 1 gear and still wont go in to over drive. check light is on ran code and it said it was the shift timing so i change both and does the same thing can. you help please, Dan Graves

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 78 Answers

Take your s-10 to a reputable trans' shop NOW!!
you have an internal problem,BUT if you'r lucky,it may just be the "range switch"on the side of the trans(hair dryer needed to heat the "goo"-sealer on the harness plug)

the trans' is in "limp(default)mode,just to keep you moving!!
driving it this way for a month WILL destroy the transmission!!

Posted on Dec 22, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont my 97 plymouth grand voyager shift into fourth gear at 40 mph?


Sticking valves. When is the last time you had the transmission serviced? Since it will shift when cold, I would suspect a valve body issue.

Dec 30, 2014 | 1997 Plymouth Grand Voyager

1 Answer

85 4x4 s10 will not shift out of low gear


If the governer gear strips,it will stay in low.
Round cover at front of tailshaft,somtimes has a metal
clip like a master cyl. cover. Pop the cover and remove the governer
(will lose a small ammount of fluid,maybe 1/4 cup)
The plastic gear on the end may be damaged.

Jan 30, 2013 | 1985 Chevrolet S-10 Blazer

2 Answers

97 cavalier starts and runs ok from a cold start after a few minutes of warm up it starts to run rough and miss. If i try to drive it it will start out ok but won't shift automaticly but shifts fine m


Sounds like possibly more than on problem, crankshaft position sensor, or ignition module likely on starting prob which maybe affecting shifting due to hard code in ecm, or shift prob could be shift solenoid in valve body of transmission. Both parts readily available from local parts store

Nov 27, 2011 | 1997 Chevrolet Cavalier

1 Answer

I have a 1997 S10 Blazer 4X4. After thing warm up


Check your tranny fluid level. Make sure you have enough.

Nov 02, 2009 | 1997 Chevrolet Blazer

2 Answers

1997 Blazer stuck in 3rd gear auto trans.


i know what you mean i have the exact same problem with my 97 blazer. it takes for ever to get up to speed and in gear,but if i shift from 1st to 4th on my own it runs fine! i dont understand the key thing either but my husband took off the plastic around the sterring coloum and therer is a little button under the iginition and if you press it in key will turn over and come out!!!! its so weird cause sometimes i crank the truck up and it takes off like it has never had a problem,and as soon as i turn it off the key comes out . then the very next time it will happen again!!!!!!!! let me know if you find out th e reason!!!!!!!!!!!!!!!!!!1

Aug 22, 2009 | 1997 Chevrolet Blazer

4 Answers

96 chevy blazer 3rd gear and overdrive slipping


i got a 1996 chev. blazer s-s10 4.3 engine 4x4.problem i got is i got 1st 2nd & overdrive & reverse but no 3rd gear what should i do

Jun 30, 2009 | 1996 Chevrolet Blazer

1 Answer

S10 blazer tansmission


You have a 4L60E whick is controled by your ECM. It sounds like you need and new transmission, the sun gear in it has failed and is the weak point on this transmission. 
When you get a new transmission have them to a corvette servo upgrade. The part is only $45.00 and the shop should know about the upgrade. It will make your truck shift a lot more firmer but last longer. 
Here is a write up http://s-series.org/component/option,com_tech_article/Itemid,/item,6/task,item/
Good luck and hope this helps

Apr 09, 2009 | 2001 Chevrolet Blazer

Not finding what you are looking for?
1999 Chevrolet Blazer Logo

254 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

81424 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...