Question about 1995 Toyota Corolla

1 Answer

Engine check on

This happens when udrive it comes up andsometimes it deosnt come up

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 740 Answers

If you are over 60,000 miles it may mean its time for new oxygen sensors. Very common when check engine-Light goes on and off. However you should have you car check for fault codes to be sure of this problem. Good Luck

Posted on Dec 15, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Engine Code PO 300 and PO 316 came up when running diagnostic

P0300 is random multiple cylinder misfire and P0316 is misfires detected on start up. This is an ignition related issue. I would check the ignition system and tune up condition and proceed from there also if you have access to a sanner with live data capability check that you have and RPM reading when cranking the engine and the times it deosnt want to start this would indicate an issue with the crank sensor

Oct 24, 2012 | 2005 Ford Taurus

1 Answer

Tall instruments jump all over,for example ill be stopped at a red light speed will show 70 miles an hour, gas will show empty, temp will be pegged out,one minute later every thing is!!!!

Unsure what you mean by Tall instruments. Meaning digital gauges or the
standard needle gauges?
Being that this problem happens to more than one gauge at the same time
and returns to normal at the same time, tells me that it might be a loose
connection grounding the instrument panel, in which could be like a needle
in a haystack to find.
One other possible way, is to check ALL fuses related to the instrument
panel for looseness, not blown, since your gauges work sometimes and
sometimes not. Hope this helps.

Dec 15, 2011 | 2000 Ford Windstar

1 Answer

Horn doesnt work chevy avalanche

  • The junction box under the hood Udrivers side by the battery) has a relay and a fuse that is the power feed for the horn. Start with checking them.


  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.

Regards, Tony

Oct 11, 2011 | 2002 Chevrolet Avalanche

1 Answer

Engine managment light flashes (glow plugs light)

the car is going into limp mode due to an engine management fault. have to check what the fault is with a code reader. if the milage is high 100,000+ could be a turbo fault (overboosting), as this will put the car into limp mode.

Feb 21, 2010 | 2005 Volkswagen Passat

1 Answer

99 jeep cherokee air conditioning no longer works. Can I leave it there and use a shorter serpentine belt and by pass the air pulley? It has a 4.0 litre engine

well if the ac just deosnt work anymore or is the pulley itself locked up. if the pulley is locked up then yes go ahead and get a bypass belt, but if the compressor itself deosnt turn on and the pulley still turns u dont need to do anything to be able to drive the vehicle other than to check the pressure in the ac system u probably have a leak that has tripped the low pressure sensor that protects the compressor by not allowing it to turn on

Jan 20, 2010 | 1999 Jeep Cherokee 4WD

1 Answer

The seat heater deosnt work

check the fuse in the main fuse box under the hood. Do you hear anything click when you engage the switch? If the fuse is ok and you dont hear the motor engage or try to move the motor probably bad.

Dec 18, 2009 | 2001 Ford Explorer Sport Trac

1 Answer

Jeep Comanche 4.0 loses spark

Check spark not only need spark, it needs good spark (should bridge at least a 1/4" gap with a strong snap and blue color.) Also, make sure engine timing is correct...If you don't have a "locked distributor" sometimes it may need adjustment. Incorrect timing can make the engine "kick back" when starting, or "lay down" while driving.

Jun 21, 2009 | 1987 Jeep Comanche

3 Answers

Oil rusty color andsometimes stalling like it doesnt want to pick up speed

If it is a 3.1 V6 then most likley it is an intake gasket leak. Get it fixed before you damage the engine. Good Luck.

May 07, 2009 | 1997 Chevrolet Malibu

Not finding what you are looking for?
1995 Toyota Corolla Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

82313 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides