SOURCE: 2007 Mercury Grand Marquis required oil weight
If u have a moderate climate, 10W-30W, if cold climate 5W-30W, do not use any heavier weight of oils.
SOURCE: rear shocks on a 1996 Mercury Grand Marquis
Raise car under frame then put jack under axle before removing the shock.
Can use locking pliers to hold the shaft from turning (may have to cut away dust boots). Top nuts are accessed and can be seen from the wheel wells or from the gap between the trunk and mount frame (can't see nut from this angle). Take care with fuel lines near the driver side nut.
Preventing shafts from turning on new shocks will be tough. Make sure you have a proper tool to fit top of shaft with enough room between top of shaft and trunk (gap decreases as the nut is tightened) so the tool can be removed.
SOURCE: location of the camshaft position sensor in a 2004 mercury sable
it is located on top of the engine right below the air inlet tube at the base of the intake it is a black sensor on top of a silver housing where the distributor would normally be
SOURCE: 2002 mercury grand marquis spark plug wire diagram
For the 4.6L V8:
Firing Order:
1-3-7-2-6-5-4-8
Cylinders:
(back of engine)
4-----------8
3-----------7
2-----------6
1-----------5
(front of engine)
Let me know if this helped...
SOURCE: where are the spark plugs located on a 2000 Mercury Grand Marquis
There are eight COPs (coil-on-plugs) to remove. Using a 7mm or 9/32" socket, remove each bolt securing each COP to the intake manifold on top of the engine. Remove all eight COPs, and the spark plugs are underneath. When replacing the spark plugs, use only the proper Ford/Motorcraft plugs, even if they cost twice as much as the aftermarket ones. You will avoid further headaches this way. Hope this helps.
572 views
Usually answered in minutes!
×