Question about 2006 Ford Ranger

2 Answers

No backup lights on 2000 ranger, bulbs are good

Posted by on

  • hankcsmith Dec 15, 2008

    bulbs/fuses good where is the backup light switch

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 405 Answers

Check bulbs first, and fuses if not it backup light switch

Posted on Dec 15, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 78 Answers

On the transmission.

Posted on Dec 15, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1992 ford ranger driver side tail light wont work but the reverse light does the bulb is good done checked that any suggestions


They are separate bulbs.
are you saying you check both of those bulbs?
if you did, and the taillight/marker light is a good bulb, then it's either the bulb receptacle, or the wiring going to it.

Apr 01, 2015 | 1992 Ford Ranger

4 Answers

How do I find electrical problem of blowing fuse to backup light when I put truck in reverse for extended period?


It could be in the reverse switch or a wire rubbed through somewhere, or the light could have bad connections, hope this helps

Dec 28, 2014 | 2000 Ford Ranger SuperCab

1 Answer

Where is the back up light switch on a 2000 Toyota Camry?


The 4 cyl manual trans uses a small switch in the side of the trans.
The backup circuit for the automatic is in the neutral safety switch on the shift rod on the side of the trans.

Mar 06, 2013 | 2000 Toyota Camry

1 Answer

How do you replace the backup light bulb in a 2000 Lincoln Navigator?


Open the rear hatch. You will see 2 bolts holding the light housing in place, remove these. They are probably 8mm heads on the bolt.Then pull straight out on the light housing. You might need to give it a few open handed smacks on the outside part of the lense to get it out of the clips. Once the housing is out there will be 2 or 3 plugs for the lights, remove the one for the reverse light by turning it counter clockwise. The bulb will pull straight out. Install new bulb and reverse the removal procedure to reinstall.
Good luck

Jan 16, 2011 | 2000 Lincoln Navigator

1 Answer

HOW TO REPLACE A BACKUP LIGHT ON A 2000 CADILLAC DEVILLE


Look for the wires leading to the light on the 2000 Cadillac Deville.
Try to figure out which one leads to the 'white' light that is for backup.
If there is a replaceable bulb, then there should be a way of rotating a socket out from behind.
Some Devilles have LED lighting for the red brake lights, I think.

May 31, 2010 | 2000 Cadillac DeVille

1 Answer

Hi I have a 2000 Ford Ranger and the air bag light is flashing


The light (on the key switch) that indicates whether the passenger airbag is on or off is, more than likely, burned out. You can either replace the whole switch ($$$) or you can take it apart and solder a new led into the circuit board. You can get the bulb at radio shack (make sure it is 12v). Good Luck!

Nov 17, 2009 | 2000 Ford Ranger SuperCab

1 Answer

How to disconnect Backup alarm ?


try replacing the reverse light bulbs with regular ones. alot of the application have a little speaker built onto the bulb. hope this helps

Jul 08, 2009 | 2008 Ford Ranger 2WD

1 Answer

Reverse lights not working on 1993 Ford Ranger


Not sure what transmssion you have but basically it goes from fuse on P/O wire to either the MLP switch on automatic or just a backup lamp switch on manual and leaves the switch on BK/PK wire to the bulbs. Should be easy to trace with a 12v test light.

Feb 05, 2009 | 2006 Ford F-150

Not finding what you are looking for?
2006 Ford Ranger Logo

Related Topics:

191 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...