The driver's side seat controls stopped working out of the blue. Neither the forward/backward or the recline controls are working. I checked every single fuse in the fuse box so I know that is not the problem.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
sounds like you might have a switch problem if the memory for seat position works ok. If you have a multimeter that checks for continuity then you could start there at the switch but you would also need a wiring diagram for the seats
Check the fuse box for a blown fuse, both seats may operate on one fuse depending on the model of vehicle and the fuse may be located either under the dash on the drivers side or in the engine compartment on the drivers side.
There are plastic gears connecting the track to the seat assembly. Whne one of these strip the seat will only work or move to one side. Infiniti does not sell a simple fix. You are looking at buying an entire seat assembly complete with the module for all the electronics. It will be at a cost of around $950 - $1000. Once that is in, Infiniti must program the seat to the brain of the car, only then can you reset your memory settings.
i had the same prob when i got my durango.i set the seat where i was cumfortable and still where my wife could be cumfortable drilled two small holes on the side of the rail and shot two rivets through it.all the other controls work the same but it doesnt go back and forth anymore.works for me ,alot cheeper than a power seat.
It is most definitely the seat slide motor. Most infiniti drivers seats have three different motors. I30, I35's and QX4's all had problems with the seat slide motors. You can tap on the slide motor which is under the front of the seat and it will probably work for a little while, but it WILL stop working completely. There was actually a Technical Service Bulletin regarding this issue because there were so many vehicles that had this problem. I hate to see that guy waste money trying to get a circuit board rebuilt that absolutely will not solve the problem.
MY POWER SEATS WILL GO UP & DOWN AND WILL TILT FORWARD & BACKWARDS BUT WILL NOT GO FORWARD OR BACKWARDS. IT JUST MAKES A HUMMING SOUND WHEN TRYING TO GO FORWARD OR BACKWARD. IS THE POWER SEAT SYSTEM A GEAR SYSTEM, OR HYDRAULIC SYSTEM?