Question about 2004 Dodge Ram 1500

1 Answer

2004 Dodge Ram 1500 4x4. Truck plugged in 30 below here. Truck turns over but won't fire. Ignition starts clicking. Any theories on what might be wrong. Wouldn't start with boost.

Posted by on

  • Car Fixer May 11, 2010

    Frozen gas line?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 6,674 Answers

As above, do you have gasline antifreeze in the tank? If you want to confirm its a fuel related problem, take rubber air intake off front of throttle body. Hold the plate, flap or whatever you want to call it open a bit, (where the air goes in to throttle body.) Give it a shot of WD-40 for about 2 or 3 seconds, then try to start it. If it fires up and runs for a couple of seconds then dies, you've got a fuel problem.

Posted on Dec 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

4x4 v8 1998 dodge truck won't start


well if ur not getting spark and u changed all of the ignition components lets think about the computer in order for the ignition to work you have crankshaft position sensor that fires the fuel injectors and the spark change that and if still nothing then change the camshaft postion sensor that sensor tells the computer that the 1 piston has came all the way up and it tells the crankshaft sensor to do its thing

Feb 21, 2013 | 1998 Dodge Ram 1500 4WD

1 Answer

I have a 1996 dodge ram 1500,the ignition won't start the truck or turn on the accessories.i have replaced the ignition switch but that didn't work.


is the battery dead or ist good check the voltage on it it should be arround 12.8 might be your alternator too

Jul 25, 2012 | Cars & Trucks

1 Answer

My truck won't start it just keeps turning over but won't start


Does it have fuel pressure? Does it have spark? check these first then post the results.

Jun 29, 2012 | 2004 Dodge Ram 1500

1 Answer

If the COIL is no good, Will the truck start?


Nope...it won't you will not get any spark to the spark plugs.
It might turn the engine over...but it won't get ignition.

Aug 13, 2011 | 2004 Dodge Dakota

1 Answer

What is a p0307 code on a dodge truck 1500 5.7 hemi 2004 the truck is missing on one cyl.


P0301-P0308....2T catalyst........2004-05 Ram...Cylinder 1-8 Misfire Detected Conditions: Any time engine is running and the adaptive numerator has been successfully updated. When more than 1.5% (300M, Magnum), 2% (Durango, Ram), 2.5% (Durango LEV, Ram LEV), misfire rate is measured during 2 trips, or with 10-30% misfire during 1 trip. 3 good trips required to turn off MIL. Possible Causes: ASD relay output 2 circuit fault Injector control 1 circuit fault Coil control 1 circuit fault Ignition wiring, spark plug, or ignition coil fault Fuel pump inlet strainer plugged Restricted fuel supply line Fuel pump module fault Fuel pressure leakdown fault Fuel injector is damaged or has failed Engine mechanical problems exist PCM has failed. Hope this helps you. Thank You for using fixya.If you like this solution please rate it....Thank You, iluv2fish....Ray

Jun 24, 2010 | 2004 Dodge Ram 1500

1 Answer

My 2006 Dodge Ram 2500 won't start. For about a month now, it would take a long time for the truck to finally start. Then I went out the other day and it would turn over but wouldn't start. Thought it was...


Check for ignition fire at the spark plugs with an inline spark tester for fire. also check the plugs for fouling condition. If you have not serviced the engine in a long time,then you might look at that as one of the problems. If you have no fire from the coil to the plugs or have worn out plug wires then replace them. The best time to locate worn or cracked wiring is at night with the hood up and doing a walk around with some one else trying to start the truck. you will see the arc's and flashes if the wires are bad. Hope this will help you !!!!!

May 10, 2010 | 2006 Dodge Ram 2500

1 Answer

When my truck is cold it starts fine when it gets


check ignition coil for fire when it is hot using a inline tester to check for fire to plugs. if no fire then replace coil. hope this will help!!

Apr 04, 2010 | 2000 Dodge Ram 3500

2 Answers

I have a 2003 dodge ram 1500 hemi im having trouble with the truck at 40-50 mph alot of jerking and no power ran codes and they said misfire at all cilenders and misfire on #6 piston and air intake running...


If you have hot air going into your engine you will have a bad fire. You could try the plugs and wires to see if it helps but it sounds like you have an intake leak somewhere. To check for a leak start your truck and open the hood and listen for hissing sound. Also check your air filter and make sure that the intake pipes are tight.

Mar 02, 2010 | 2004 Dodge Ram 1500

1 Answer

When its below 30 degrees or so, my 2005, my Dodge


1 or more of your glow plugs are out....glow plugs heat your fuel in cold weather to help it start...thanks and have a great day

Jan 03, 2010 | 2004 Dodge Ram 3500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...