Question about 2006 Chrysler PT Cruiser

1 Answer

Have 2006 pt cruieser with no dash ortaillights also no parking l

I turn on headlights have headlights but no dash or taillights when i turn on park lights have no park or dash or taillights

Posted by on

  • Anonymous Dec 30, 2008

    The Dashboard Panel went out completly, the Speedometer does not move, nor does the Fuel gage

  • Anonymous Mar 30, 2014

    lights go dim or turn off

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 512 Answers

Check all the fuses in the fuse block for power on both sides....if none are blown its possible the fuse bank module itself is bad

Posted on Dec 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the headlight relay located?


In relay box in engine bay..

Aug 23, 2014 | Cars & Trucks

1 Answer

No taillights park or dash lights


check park/tail fuse regarding dash ,park ,tail problem .brake light on passenger side is probably the brake globe needs replacing .Turn signals on passenger side could be globes or switch,check globes first ,if globes and fuse are ok ,may well be the switch especially if park switch and turn signals are on the same switch lever/stalk

Jan 15, 2014 | 1990 Buick Century

1 Answer

I have a very clean 89 Crown Victoria from Florida! An old lady owned it bought brand new! I resently replaced all external lights now when I turn on my lights all my front turn signal lights my dash...


The dimmer switch for the headlights only affect the headlights. The dimmer control for the dash lights only affect the dash lights.
So if the parking lights are going off too, I would say its the headlight switch. Thats about the only thing that involves all three circuits.
It could also be the harness plug at the headlight switch.
BTW - the turn signal lights are another circuit from the parking lights.

Dec 20, 2012 | Cars & Trucks

1 Answer

I have a 1993 GMC Sierra. If the headlight or parking light switch is on nothing works in the tailight assembly. Blinkers work in the front but blink quickly.Replaced taillight circuit boards with new...


I'd be willing to bet your dash lights don't work either when you turn the headlight on.change the headlight switch, it has a short, it's only about 11 dollars at advance auto, and is fairly easy to replace. my 93 chevy did same thing, changed headlight switch, problem solved

Sep 09, 2012 | 1993 GMC Sierra K1500

1 Answer

I turn my car on and then turn the headlights on. The taillights do not come on. When I turn my car off my taillights come on.When I leave my car in the off position then I turn my headlights just to park...


Sounds like your lights switch is coming apart. Recommend you remove the switch and test it with an ohmmeter. To remove the switch, pull the knob straight off, reach behind the dash and push in the 3 tabs (top, left, and right side) holding the switch in, pull the switch back under the dash, and remove the connector. To test, use the pinouts shown on the diagram below and the switch pictured. Basically, pin 2 should have 1.2 Kohm resistance to pin 7 in the OFF position and no continuity elsewhere. Similarly, in PARK, pin 2 should have 1.2 Kohm to pin 8 and no continuity elsewhere. In the HEAD position, pin 2 should have 1.2 Kohm to pin 4 and none elsewhere.

If the switch has failed as I suspect, you will find that in the OFF position, pin 2 will have 1.2 Kohm to pin 8 rather than pin 7.
Let me know if you have questions.


f157327.gif
1787053.jpg

Oct 24, 2010 | 1999 Ford Windstar

1 Answer

Inoperative taillight,dash lights,and fog lamps on


i have 2001 Audi is a liking gas problem

Mar 14, 2010 | 1996 Pontiac Grand Am

1 Answer

2006 Toyota Sienna Taillight will not work I had remote start installed and when you remote start the tail light and parking light will flash indicating car is remote started. Problem: When I put the key...


Bypass the fuse? Bypassing a fuse is a fire hazard in the first place. When they worked on that everything should work normally plus the added feature. Not compromising anything. Take it back there and have it done properly or put it back the way it was, and have it done somewhere else. You work hard for your money so you deserve a good job on your car.

Nov 14, 2009 | 2008 Toyota Sienna

2 Answers

Shut off daytime running lights?


You can't disable them it's illegal. If you need to shut them off while the engine runs say at drive-in, apply the parking brake (this works on some but not all cars, and don't try driving with parking brake engaged just one click).

Apr 16, 2009 | 1999 Toyota Corolla

1 Answer

1998 XJ8 Vanden Plas taillight problem


Check the electrical grounds for the taillights. In fact, get a diagram and check all the easily accessible grounds. Many of these are in the engine bay.

Dan

Jul 29, 2008 | 1998 Jaguar XJ8L

Not finding what you are looking for?
2006 Chrysler PT Cruiser Logo

293 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...