Question about 1998 Ford Windstar

2 Answers

Transmission transmisson will not go in gear. no fluid leaks, also will not go in park

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The gear box, don´t walk to the front, only walk in reverse

Posted on Feb 18, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 141 Answers

Check to see if the shift cable free, frist i would disconnect the cable at the trans please make sure you have the wheels chocked up . with the cable disconnected move the shifterif it moves freely go to where you disconnected at the trans and see if you can move the shifter arm if you can the cable has most likley failed. our the shift tube has failed on the columen has failed good luck

Posted on Dec 23, 2008

1 Suggested Answer

  • 180 Answers

SOURCE: Transmisson stopped working while travelling on highway

A complete failure like you have described leads me to suspect a torque converter failure.

Posted on Feb 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

94 caddy sedan deville 4.9 transmisson wont engage into any gears


If you are sure the fluid level is full, the filter could be leaking pressure or not allowing fluid to pass thru. There may not be enough fluid in the valve body to make the transmission function.

Jun 09, 2013 | Cars & Trucks

1 Answer

F250 1998 light duty won't shift out of park


For car not changing gears and not shifting out of park mode ,it can be shifter assembly issue, or it can also be transmission issue. Get the shifter assembly inspected with ignition OFF.

For more troubleshooting, I suggest you to get the Following help link checked, its complete step by step procedure to inspect gear shift issues: -----

GEAR SHIFT ISSUES

http://alltypesofpartsreplacing.blogspot.com/2012/11/gear-shift-issues.html

==========


NO REVERSE ON TRANSMISSION
http://alltypesofpartsreplacing.blogspot.com/2012/12/no-reverse-on-transmission.html
-------------

Transmission fluid leak, transmission gears slip,
http://alltypesofpartsreplacing.blogspot.com/2012/12/transmission-fluid-leak-transmission.html
----------


These will help.

Thanks.

Dec 06, 2012 | 1998 Ford F250 SuperCab

1 Answer

Where do I check my transmisson fluid?


Fluid Level Checking Procedure for all Transmissions without a Dipstick:

  1. The transmission temperature must be between 30°C and 50°C before checking can begin. Use the DIS or the MODIC to determine the transmission temperature.
  2. The vehicle must be level and without load. With the engine running, switch on the air conditioning. This will increase the idle speed and ensure that all oil passages in the transmission are filled with oil.
  3. Step on the brake firmly, apply parking brake fully and move the selector lever through each gear position, pausing briefly in each gear.
  4. With the engine running and the selector lever in Park position, remove the filler plug located on the transmission (see picture for location). If a small stream of oil runs out, the fluid level is correct.
  5. If no oil runs out when the filler plug is removed, the fluid level is too low. Add oil until it starts to overflow.
  6. With the engine running, reinstall the oil filler plug and tighten to proper torque. (Refer to section below for proper tightening torque)
#1 is the drain and #2 is the filler


360dreamworx_5.jpg

Jul 31, 2011 | 1996 BMW Z3 Roadster

1 Answer

Transmisson not shifting all gears. the d does not light on the dashboard when in drive it only shifts 2 gears


An easy solution is to make sure your not leaking transmission fluid and you have enough fluid in the vehicle.

Feb 04, 2011 | 2000 Lexus RX 300

1 Answer

Transmisson problems


Try checking the transmission fluid level first to see i it is full and then look at changing the filter and gasket on the transmission and if you still have you will need to take it to atransmission shop to have it loked at, but try the things I mentioned first okay.

Sep 12, 2009 | 1998 Ford Windstar

1 Answer

1995 subaru legacy with an auto transmission


First Did you take the emergency barke off? and have you checked the fluid level? even a pint of fluid can damage transmissions. look at fluid is it brown? if it is you need to change the oil and filter in the transmisson. Does it go in reverse?

Aug 28, 2009 | 1991 Subaru Legacy

1 Answer

Problems with the transmisson


Whit the engine ruining check your transmission fluid level
is possible than you have a transmission fluid leak and don't have enough fluid to work properly. NOTE: Do not ever fill it because that can case your transmission to wear out faster.
And make sure the car is on a level place and the engine is running while you check the level.

Jun 17, 2009 | 1993 Subaru Loyale

1 Answer

TRANSMISSON FILTER


drain the the fluid from the gear box .and refill with a good auto transmission fluid a.t.f. as the fluid breaks down due to heat

May 04, 2009 | Hyundai Motor 2003 Elantra

1 Answer

Transmisson stopped working while travelling on highway


A complete failure like you have described leads me to suspect a torque converter failure.

Feb 20, 2009 | 2004 Chevrolet TrailBlazer

Not finding what you are looking for?
1998 Ford Windstar Logo

Related Topics:

218 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...