Question about 1989 Peugeot 405

1 Answer

Brake change need to change front brakes on 406 hdi 1999. never done it b4, need help thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 166 Answers

Very easy to do but you have to be careful the disks on these cars wear out very quickly and more often then not need to be replaced, off the top of my head i think the min thickens is 24 mm but play it safe if there is a big lip on the disk get a new one as a under size disk can end up killing you if your not careful.
all you need for the job is a 13 mm spanner and a screw driver.
remove the wheel and place the screw driver into the top off the caliper and pull back this should push rhe pistons back than undo the lower caliper bolt and remove pull out old pads and shims and replace with new ones.
refit new caliper bolt and refit wheel pump break peddle until firm and then check the brake fluid level youmay have to remove some be shore to check the brake operation befor driving any were

any questions please ask me

good luck

Posted on Dec 20, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is coolant sensor on a peugeot 406 hdi please


I know this sounds weird, but check on the mirror housing( pass. side) it should be located in the mirror.

Jan 25, 2015 | 1999 Peugeot 406

1 Answer

Peugeot 406 hdi faults


Cam belts are due every 120,000km on peugeots. You should be fine for quite a while.

Sep 07, 2014 | Peugeot 406 Cars & Trucks

2 Answers

Peugeot 406 hdi electronic immobiliser warning


The ignition key may be defective or in need of a battery to generate the code needed to disarm the immobilizer. Hope this helps!

Mar 05, 2010 | 2005 Peugeot 405

2 Answers

I have a warning light on dashboard of peugeot 406 hdi and


sounds like a fault on traction control or abs
check the abs rings on the front drive shafts

Nov 10, 2009 | 2005 Peugeot 405

1 Answer

I have a pug 406 2l hdi i have had a problem with the breaks


That sounds like a bad brake rotor or drum. If the brake rotor or drum is thick in one spot and normal on the rest that will cause the pedal to pulsate every time the the rotor or drum reaches that part of its rotation. The solution to this problem is to remove the front and rear rotors or drums and take them to a machine shop so they can be smoothed out, bear in mind you may need to replace them if the thick spot is too great.

Oct 22, 2009 | 2005 Peugeot 405

1 Answer

Peugeot 406 HDI ignition fault


sounds like a defective brake light switch that's stuck.

Sep 02, 2009 | 1984 Toyota Celica Supra

1 Answer

Peugeot 406 hdi 2000 [Wreg] front @rear fog


Send me your car chaisses number to get the wiring diagrem for helping

Mar 02, 2009 | 1991 Peugeot 405

2 Answers

Injectors


Injectors from the same ccm engine are most probably sounds same but to be on the safe side check not only the shape but code on the top of injector too. Because they are piezo effect injectors and set by the manufacture for a specific pressure for specific engine codes.

May 22, 2008 | 1990 Peugeot 405

2 Answers

Injectors


No, the size of the cars is different, so it wont work.

May 22, 2008 | 1989 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

63661 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...