Question about Jaguar X-Type

1 Answer

How do i remove the front bumper on my x type jag

Posted by on

  • Colin Stickland
    Colin Stickland May 11, 2010

    jack it up and look for the fixings after removing the wheel arch plastic covers must be some bolts somewhere

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 43 Answers

1/Remove bumper under tray.
2/ " the front of both inner wheel liners.
3/ " a 10mm bolt at top behind both marker lights.
4/Remove 2 10mm bolts above both headlight assemblies.
5/Cautiously withdraw bumper then disconnect bumper harness.

Posted on Dec 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My jag series 3 1985 . blows cold air .and blows hot when it wants too .


THEIR IS A VALVE ON THE RIGHT SIDT OF THE VECHILE HEATER VALVE RIGHT AT THE FRONT JUST BEHINED THE BUMPER THAT NEEDS CHANGIND OR CHECK THE CONNECTIOS TO IT FIRST.

Nov 06, 2013 | 2000 Jaguar S-Type

1 Answer

Jaguar x type 2004 front bumper


Front bumper removal is quite easy. To start with there is 4 10mm bolts one by each headlamp ( with the bonnet open) remov them. There is 3 T30 screws that hold the under tray to the subframe and there is also a small corner trim that is on the bumper side of the front wheel arch here is 3 T30 screws holding them on on each side. Finally remove the front wheel arch lining so you can get acsess to the inside of the bumper. You will then see a 10mm bolt towards the top of the bumper that is reversed to you. Remove then the bumper should then just pull away.

Becareful not to damage the fog lamp harness upon removal

Apr 08, 2010 | 2004 Jaguar X-Type

1 Answer

My jaguar stype's heating cannot be controlled - it comes out constantly hot. Last week I changed the ambient air sensor which was effective in displaying the fault on the temp gauge of the outsede air...


Hi,

I had this problem about a year ago on my 2004 S Type diesel. It's not uncommon and the end result was that it's a wiring fault in the front wiring harness. This is a major hassle to fix and involves taking the fron bumper off. The Jag main dealer did this but the problem came back. I checked other forums and it seems there was a batch of rogue wiring harneeses which Jag bought cheap from Romania in 2004 and fitted to S types. These had moisture in them when manufactured so eventually most of the wires corrode over time - but from the inside! Jag know about this but will not fix under warranty. I ended up spending £1200 to have a whole new front wiring harness fitted - problems gone away now.

Mar 13, 2010 | 2004 Jaguar S Type

1 Answer

How do I remove the headlamp unit on a Jaguar S type 2001 I can only see two nuts one top centre and one to the left and three or four inches lower slightly to the right of the main beam looking from the...


Front bumper requires removal to gain acsess to the lower 10mm bolts. Bumper comes off by removing the 2 10mm bolts on the top of the bumper then unscrew the 2 T30 screws in the front wheel arch liner (bumper side) and then you will be able to see a 10mm bolt reversed into a bracket at the top of the bumper from a inside veiw, remove and repeat for the other side. Then its 3 10mm bolts that secure the front under tray (if yours has one). Then there will be another 10mm bolt to the wing side of the headlamp from a above veiw. Bumper should then just pull off and watch for the connector for the fog lamp harness.

Just the 2 lower headlamp bolts andit should pull from its housing

Mar 04, 2010 | 2001 Jaguar S-Type

1 Answer

S Type Jaguar rear bumper removal


how do you remove a front bumper off of an jaguar s type?

Mar 09, 2009 | 2004 Jaguar S Type

1 Answer

How do you remove the front clip of 02 x type jag.


That Means the Entire Front End. Please Rate my Solution, I need all the Help that I can Get! Thanks!

Jan 29, 2009 | 2003 Jaguar X-Type

1 Answer

I WANT TO FIT A TOWBAR TO MY 05 REG X TYPE ESTATE JAG


Yes you do need to remove the bumper, remove the 2 torxs screws in each wheelarch, 1 upper bolt and 1 lower bolts behind the wheelarch liner each side. two nuts inside car each side along upper edge, 4 nuts behind trim on rear edge, and 3 plastic plugs along lower edge. Hope this helps

Jan 26, 2009 | 2007 Jaguar X-Type 3.0 Sedan

1 Answer

1996 XJS Front End Bumper/Spoiler


thier are companies that sell OEM parts cheaper and they arrive undamaged. I can get that bumper for 225.00 in threedays

Jul 02, 2008 | Jaguar XJS Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

608 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Raygin
Raygin

Level 2 Expert

322 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...