Question about 2004 Jeep Grand Cherokee

1 Answer

03 Jeep Grand Cherokee Driver side window

Need help removing door panel on driver side

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,176 Answers

There are about 3 or 4 screws holding some molding at top and around the arm rest remove them. Starting at the bottom or back of panel put a small screwdriver or similar object between panel and metal of door and start prying slowly. You will need to buy replacement clips because usually they break when removing, but they are not that expensive. Just take your time and its not that hard. Had to take both off of wifes jeep to replace motor

Posted on Dec 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My window on my 03 Grand Cherokee driver side rear is stuck down and will not go up all the other windows work fine from driver side controlexcept the rear window on the driver side now it is stuck down...


You will have to remove the door panel

Most likely you have a broken window regulator
& are not going to get it up

If it is a switch problem,only,then you unplug the
motor & put battery voltage direct from the battery,
to get it up, until you have time to work on the problem

Dec 02, 2014 | 2003 Jeep Grand Cherokee

1 Answer

Drivers side window on a 2005 Jeep Grand Cherokee falls off track


Have to remove the inner door panel,
to see the problem
Most likely a broken window regulator

Jul 13, 2013 | 2005 Jeep Grand Cherokee

1 Answer

On my 2004 Jeep Grand Cherokee V8, the driver door control for the rear passenger side window does not work up or down, but the window control on the rear passenger side door works to make the window go...


Check wiring harness in between door and body, most likley there is a broken wire in this harness.
To get the window up you will need to remove the panel and apply a power and ground direcly to the moter connector. if it does not go up then reverse the polarity

Feb 18, 2011 | 2004 Jeep Grand Cherokee

1 Answer

Power windows don't work on all 4 doors and power lock doesn't work on the driver door. 2004 jeep grand cherokee


On the driver side, the window/door lock module has the power lead either pulling away from the connection or has broke entirely. Another common cause is the wire harness between the door jam, this is the area that has a rubber boot covering the wires and from opening and closing the door, it creates a broken or loose connection over time. Open the driver side door, grab the rubber boot that the wires run thru, and move it around. Some times this will help create the connection and restore the power. If not, the door panel will need to be removed to inspect the wire connections.

Dec 31, 2010 | 2004 Jeep Grand Cherokee

1 Answer

1997 Jeep Grand Cherokee Laredo 4 x 2, windows and door locks work on driver side, but not passenger side.


sounds like an open power or ground circuit on passenger side,since the door lock and the window,lost its functioning.Both switches would have to be bad at the same time,which is not probable, to be the fault. Unless there is a saftey lock out switch on the drivers panel,controling the passenger side door lock and window.

Sep 02, 2010 | 1997 Jeep Grand Cherokee

2 Answers

How do you remove the driver side door panel on a 2004 Jeep Cherokee.


- Remove trim plug from mirror flag bezel.
- Remove screws attaching trim panel to door
- Using a trim remover, detach trim panel perimeter push-in fasteners from door trim panel
- Lift trim panel upward and separate from door.
- If equipped, disconnect harness connectors for power accesories.
- Disconnect latch rods from inside handle actuator
- Finally, separate trim panel from vehicle.

I suggest check all information in the WJ Repair Manual Section 23 Body with graphics and other details.

Good luck (remember rated this help).


Feb 03, 2010 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Passanger window just fell down, when i shut the door.


jUST REMOVE THE SCREWS AT BOTTOM AND POP HANDLE BLANK OUT A LITTLE SO CLIP CAN BE REMOVED AT HANDLE MAKE A **** PULLER OUT OF AN OLD PUTTY KNOFE AND CUT A SLOT IN IT . bUT GOOD ENOUGH FOR KNOW .

Jun 14, 2009 | 2004 Jeep Grand Cherokee

2 Answers

Driver side window works intermittenly / 95 jeep cherokee.


try knocking lightly on the door panel insert between the armrest and the window. i have the same problem with mine and it works.

Apr 19, 2009 | 1998 Jeep Grand Cherokee

1 Answer

Window motor replace 2001 jeep grand cherokee


You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.

Apr 18, 2009 | Jeep Grand Cherokee Cars & Trucks

3 Answers

1999 Jeep Grand cherokee


Check the wiring between the drivers door and the A pillar(the body of the car). Sometimes the harness breaks from opening and closing the door.

Nov 07, 2008 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...