Instructions
Difficulty: Moderate
Things You’ll Need:
-
Set of ¼-inch drive sockets
¼-inch drive ratchet
Set of ½-inch drive sockets
½-inch drive ratchet
Set of 3/8-inch drive sockets
3/8-inch drive ratchet
Set of metric wrenches
Floor jack
Jack stands
Step
1
Raise and support the
vehicle
on jack stands. Remove the intake air temperature wiring, the breather
hose and intake air hose. Take off the air cleaner assembly.
Step
2
Remove the right wheel. Remove the accessory belts. Remove the
crankshaft bolt and the crankshaft pulley. Remove the power
steering
bolts and the timing belt covers. Temporarily install the crankshaft
bolt and turn the engine clockwise until the mark on the crankshaft
pulley, which is a triangle stamped into the crank sprocket, is aligned
with the corresponding triangular mark on the block.
Step
3
Make sure that the timing marks are aligned on the camshaft sprockets.
These are a line on each sprocket that runs through a tooth on each
sprocket. These lines should line up in the middle between each
sprocket and point toward each other. If they do not line up, turn the
crankshaft one more time and they will line up. It takes two turns of
the crank to one complete revolution of the cam.
Step
4
Loosen the water pump bolts; using the 3/8-inch ratchet, turn the water
pump clockwise away from the belt and loosely tighten the bolts to keep
it there. Remove the
timing belt.
Make sure the timing marks are aligned and install the new belt
starting on the right side from the crank sprocket and working
counterclockwise. Keep all the belt tension on the right side away from
the tensioner.
Step
5
Loosen the bolts in the water pump and rotate the water pump
counterclockwise to apply tension to the belt. Watch the tensioner,
which is above the water pump, and apply tension with the water pump
until the pointer on the tensioner lines up with the notch above it.
Lightly tighten the water-pump bolts.
Step
6
Turn the
engine
two more times and align the timing marks perfectly. Loosen the
water-pump bolts and, using the ratchet, apply tension to the belt
until the tensioner pointers are aligned. Tighten the water-pump bolts.
Step
7
Install the timing-belt covers and the bolts in the power-steering pump
and tighten. Remove the crankshaft bolt and install the crank pulley
and the bolt, then torque the crankshaft pulley bolt to 70 foot pounds
of torque. Install all components in reverse order of removal.
i need timing belt diagram of daewoo nubira car
I need pics also timing marks daewoo nubria cdx
How do I program a new key for my 2001 Daewoo Nubira?
×