I have a 95 sl2. Had a vibration when I turned left. I changed the cv joints, balljoints, then 30 miles later. I pull up to a stop sign, car pops outta gear! I pulled the motor and trans. Have not pulled the ****** yet , Not sure what I'm lookin for? Thinking the diff pin? Any help would be greatly appreciated! Thanks.. Jacob
My first guess would be the axle shaft has popped out of one side of the transaxle. They can be tough to get in far enough for the lock ring to hold.
SOURCE: 1997 Saturn SL2 Sunroof problem
it sounds like the motor's gears went. I had the same problem. To see if it is the motor or track drop the headliner down a lil in the front near the map lights. Then push up on the center of the motors drive with a flat head screw driver and turn if the sunroof opens then it is the motor if not it is the track. You can buy new or use cost is up to you her is one on ebay. http://cgi.ebay.com/ebaymotors/99-SATURN-POWER-SUNROOF-MOTOR-96-97-98-404-328_W0QQcmdZViewItemQQcategoryZ50459QQihZ018QQitemZ280272955699QQrdZ1QQsspagenameZWDVW#ebayphotohosting
SOURCE: 93 Saturn SL2 won't start
check your fuses, and intake valve, and also get a battery test. I believe those are free.
SOURCE: 97 Saturn SL2 won't turn over
Check the neutral-saftey switch. If it is a clutch, the starter will generally engage and the car will generally lurch forward. Most newer cars are equiped with a switch that detects when the car is in-gear & wont permit it to turn over. Could be the clutch but go for the cheap fix first.
SOURCE: 98 Saturn SL2, manual trans. No reverse or 5th gear.
THE PROBLEM IS FRONT WHEEL BEARINGS it sounds like a helecopter or a huming noise.U should fix it right away it could cost u lots in parts if u wait to long wheel bearings 50.00 to 200.00$ on some cars
SOURCE: my 2000 saturn sl2 turn signals stopped working
HI"
Vehicles:
Make/Models:
Model/Build Years:
SATURN/LS
2000
Defect:
VEHICLEDESCRIPTION: PASSENGER VEHICLES. THESE VEHICLES DO NOT COMPLY WITHREQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, ANDASSOCIATED EQUIPMENT." BECAUSE OF A PROBLEM IN THE HAZARD WARNINGSWITCH ASSEMBLY, THE TURN SIGNAL LAMPS MAY NOT WORK OR MAY WORKINTERMITTENTLY WHEN THE DRIVER USES THE TURN SIGNAL LEVER OR HAZARDWARNING SWITCH. IF THE VEHICLE TURN SIGNAL INDICATORS ARE NOT FLASHING,THEN THE TURN SIGNAL LAMPS MAY NOT BE FLASHING.
Component Affected:
EXTERIOR LIGHTING:TURN SIGNAL:SWITCH
Corrective Action:
OTHER DRIVERS MAY NOT BE ALERTED THAT THE VEHICLE IS TURNING AND A CRASH COULD OCCUR.
Consequence:
DEALERS WILL REPLACE THE HAZARD WARNING SWITCH ASSEMBLY.
Mfr. Campaign #:
99045/00-C-03
Mfr. Involved:
GENERAL MOTORS CORP.
# Vehicles Affected:
1395
File Date:
07/29/1999
The vehicle you are working on may or may not be affected by this recall. Contact the vehicle manufacturer for clarification. hope this solves your problem.THANK YOU
148 views
Usually answered in minutes!
This site must be kid friendly. ****** = Trans I put a Y on the end. Crazy!
Also After I replaced the whole front end I thought I't musta been a wheel bearing. I wasnt that bad....If it is the differental has anyone replaced one ? How much Thanks Im almost ready to scrap it but it only has 110.000mi and drove by my 80yr grandma most of its life..
×