Question about 1988 Lincoln Mark VII

1 Answer

Rear suspension The rear suspension went all the way up on my 88 LSC and will not go down,even with the switch off.what could be the problem?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 373 Answers

Rear sensor is bad, replace and check height is set were you need it.

Posted on Feb 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Mark 8 LSC collectors series car. Where is the air suspension control module?


The air suspension module is located on the RF kickpanel. It is the black module with 2 connectors going to it. One black and the other white.
air-suspension-control-module-1998-mark-hohsqb5cqdswcx1wahyyf1rv-4-0.jpg

Jun 10, 2015 | 1998 Lincoln Mark VIII

1 Answer

Suspension 2000 Mercedes s 430


that is why your suspension went down. is that just a bracket or the arm off of the level sensor? it will need to be repaired for the car to maintain correct level.

Nov 30, 2014 | 2000 Mercedes-Benz S-Class

2 Answers

1994 lincoln continental executive rear end goes down when the car is parked few hours.


When the key is off, the air suspension shouldn't lose any air, so you could have a valve leak in the system. I'm not familiar with all the components of the system, but did you check the valve that allows the system to bleed off pressure for leaks when the system is turned off?

Jan 13, 2014 | 2004 Lincoln Navigator

1 Answer

Have a 2000 eddie bauer and the entire rear end is sitting low with the front remaining the same, this seems to be happening often, whats the solution


do you hear the pump running from under the back of the car? check fuses? is the suspension light on in the dash? this system is diagnosable with the right tester.have someone get the fault code from the suspension module. could be as easy as a sensor. was the car towed recently? flat beds ofter knock off the sensors when car gets tied down. my air suspension went out on me. And the dealers price was too expensive and i went to Strutmasters.com and bought a conversion kit that eliminated the air and has a lifetime warranty so now i don't have to worry about it ever again. Prior to jacking or lifting a vehicle with air suspension, you must turn off the suspension switch. find the reset switch auto parts store will tell you where its at

Dec 04, 2010 | 2000 Ford Expedition

1 Answer

The rear suspension is down on my 1999 Ford Expedition - Eddie Bauer. The cause: while out in the woods I came across a small dip which cause my back left wheel to lift off the ground. The suspension...


I had a 1999 Expedition. When you put the 4x4 on it raises the vehicle an extra inch or 2.
It may help to turn the 4x4 off. Two wheel drive is a lower air setting.
Your original pump may still be good. The problem can be in the front. The compressor is not filling the front suspension to the cutoff point. It will lift the rear after the front end is at running height. Since you lost the front end first, the remaining air bled out there and then the rear came down. Once you shut down the car the suspension was done, all the air was let go.
There are adjustment solenoids on the body but you need someone qualified to repair this.

Sep 05, 2009 | 1999 Ford Expedition

3 Answers

Electronic pneumatic suspension on 2000 subaru legacy estate


You need to check the hieght sensor in the front springs. It may have been extended to far and stuck or broke. It determines the load and adjusts the pressure to each spring. Good luck and have a great day.

Jul 08, 2009 | 2001 Subaru Legacy

1 Answer

I have a 1990 Lincoln LSC that has the air suspension turned off. it was this way when i bought the car. Should i turn it on or just keep driving with it off?


It has a cut off switch because you need to cut it off before jacking up the car or putting it on a lift.This keeps the air suspension from over inflating when jacking or lifting the car.Turn it back on . refer to owners manual

Jun 24, 2009 | 1998 Lincoln Town Car

2 Answers

Temperature switch location 89 lincoln mark 7 lsc


for the temp..check the sensors. your thermostat only controls the water/antifreeze flow. the switch in the trunk may be an engine or fuel tank shut off switch. the speakers' wires may have a short..its also possible that the wires that are connected to the radio may be loose.

May 24, 2009 | 1989 Lincoln Mark VII

5 Answers

1990 Lincoln mark VII lsc


Experienced problem after problem with my suspension on my 1990 LSC. Finally contacted "Strut Masters" online and replaced my entire system with a conversion for less than 400 and an afternoon. Installation was simple.

Feb 02, 2009 | 1990 Lincoln Mark VII

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...