SOURCE: 1999 jeep cherokee power windows
usually it is a wiring issue i would start by checking the wires that run between the door and body of the vehicle. they always break inside that black rubber boot. and the way jeep wires the doors, everything goes though the drivers door switch even the power that feeds the other doors
SOURCE: PASSENGER POWER WINDOWS NOT WORKING IN 2001 JEEP CHEROKEE
Hi!
To resolve the issue you are facing with you need to check the following parts—
1. Battery voltage at window switch. If no battery voltage at that switch, check for broken wire between door and body it means the motor of the window has gone bad.
2. If window can be operated by driver switch or individual switch it means window switch has gone bad.
3. If the pin connectors are broken then it means the switch connector of the window has become unserviceable and need replacement. If none of the non-driver switch is working then it is a bad lockout switch.
Please check all the above possibilities and repair/replace whatever is gone bad.
Thanks for using FixYa
Please revert for further assistance.
Thanks
Rylee
SOURCE: 2000 jeep cherokee classic all power windows only
Mate.I would say the lockout switch on the drivers switch panel is playing up.Take the panel off and check for loose wiring or broken switch.Hope this helps
SOURCE: Jeep Cherokee side mirror install
You have to remove the door panel to access the mounting bolts. Once you remove the screws that secure the handle and other components from the door panel, the panel will pop off when you pull it outward. The top of the panel will come off when you push up after lossening the bottom and side clips. There a flat tool that is used to release these clips, but they do break when you try to remove them, but are easily purchased at any auto center.
There are three bolts to remove the mirror. If you have the rare heated rear view mirror option, you'll have to disconnect the harness before removing the mirror.
214 views
Usually answered in minutes!
×