Question about 1999 Mazda B-Series

2 Answers

Mazda 1997 E2000 VAN, WIPERS WORKING only dead slow, replaced motor, switch & control

Posted by on

  • Beth M May 06, 2013

    when I turn on aircon of my 1997 mazda E2000, engine starts to overheat after an a hour or a half run. What seems to be the problem then?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

I'm no expert but to me it sounds like it could be your battery or alternator or something to do with the electrical system, have you had your battery and charging system checked by an auto-electrician?

Posted on Jan 27, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi fixya pls i need a mazda e2200 van to buy and my name is fitzgerald from west africa ghana . and email address is kengfiz@co.uk

Posted on Jan 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wipers only work on slow intermittant


front or rear, guess front... gee?
you meant fails only on high and fails means dead, rigth, not slow on high or some other odd effects. like noise. chattering or ?
what does it do on high , i guess sits still.
the wipers can be slow. if the motor is weak.
fail to return
make noises. or jam.
Q1:" do the washers work

2004 WJ
there are 3 things, POWER< CONTROLLER and MOTOR.
the first question here, is this computer controlled (eg BCM)
answer: YES, the BCM does keep alive. (more later)
is there a relay?
answer yes.
the control has 10 position.. off 1....9
so intermattant 1 to 5 work, you never said that.
at pos. 6 is low, works.
at post 7 high its dead. it turns on the HIGH wiper relay in the PDC
so that is dead,
my guess. i use meters to tell me facts but if i hand to guess
it be the HIGH relay blown.
if not its the H tap pin on the motor bad.
or wires to same.
the wiper motor can be hot wired to test it. easy
pin 6 on the motor connector is hIGH./

if how ever the high starts the wiper moving and then dies
then the PCM keep alive feed is dead. or wiper on./off is dead.
but the other work, so id skip this.

try to say exactly what happens on high. (DEAD?)
OR MOVES AND STALLS.? O short strokes.?

Jan 03, 2016 | 2004 Jeep Grand Cherokee

1 Answer

How to remove or replace mazda e2000 speakers


I suggest you tube tutorials...they're step-by-step and you can find one on just about anything!

Jun 09, 2015 | Mazda Cars & Trucks

1 Answer

1997 mazda e2000 van which is blowing black smoke


if it takes 5-10 mins of running before black smoke disappear i think you could have broken rings causing engine oil into the combustion chamber. you could observe white smoke if you have just changed oil.
solution would be to replace piston rings. it would save u a lot if u could diy.

Nov 24, 2013 | Cars & Trucks

1 Answer

Wipers only work on the highest stetting have already replaced the motor and the switch in the cab on the collum in a 1994 mazda b2300 base edition


Mazda is the same as a Ford Ranger. There is a wiper relay under the dash that goes bad. It will work on fast but not slow or delay. Just take the cover off and follow the wires from the lever or switch on the column and they will lead to a box, which is the relay. Then the wires goes out to the motor. I had this problem on two trucks.
Jeff

Mar 13, 2010 | Mazda B2300 Cars & Trucks

1 Answer

Mazda 6 fuel pump wiring dirgram


Mazda 2004 E2000 van had air metre replaced as it was burnt out, lost power so disconnected battery and reconnected 1hr later. Power did improve but now has slow pick up and very sluggish on hills. It is dual fuel ( petrol/lpg ) but is the same on both fuels.

Jan 07, 2010 | 2003 Mazda Mazda6

1 Answer

1997 dodge caravan se 6cyl 3.3


I think you need to replace the Body Control Module (BCM), My newly replaced BCM (used) fixed my wiper problem but created a new problem which the left turn signal is not working now. Time to sell the van.

Jun 18, 2009 | 1997 Dodge Caravan

1 Answer

Plymouth Grand Voyager SE, 1997. 3.0 litre


check to see if you have life at the wiper motor plug.if not.you have a dodgy switch.

Jun 10, 2009 | 1997 Plymouth Grand Voyager

Not finding what you are looking for?
Cars & Trucks Logo

259 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...