Question about 1994 Chevrolet S-10 Blazer

1 Answer

How can I remove the 1994 S-10 Blazer driver side seat belt cover

The lower part of the seat belt won't retract but I can't find a way to remove the cover. There appears to be a rivet (?) that holds it in place.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 2 Answers

Grab it fromthe bottom and it should unsnap unless it has a phillips screw on the bottom then there is a bolt holding it in

Posted on Dec 14, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Remove the back seat center seat belt

the quickest way is to pull hard on the belt it shouldpull out might be tough but should work otherwise the cover will have to click off usually theres not a bolt holding it but really try to get it pulled back through hope this works for you

Jan 06, 2015 | 2003 Saturn VUE

1 Answer

How do I remove the original seat covers from a PT Cruiser driver seat

get under the front seats there are 4 bolts holding the seats in the floor plus a torx bolt for the lap belt, take seats out the back seat has 2 torx bolts at the front bottom of the lower cushion remove them and pull the bottom forward the back has 2 bolts holding it remove them and lift the unit straight up, be carefull there is wires under the front seat for the seat belt warning light carefully unhook them 1 for each seat now you need hog ring plairs and a bunch of new hog rings to secure the new fabric, use side cutter plairs to remove old hog rings carefully remove the seat covers, hog rings can be got at car glass shops the pliars can be got from summit racing or a place that sells car uppolstrytake your time and you can do it!!

Oct 29, 2014 | Chrysler PT Cruiser Cars & Trucks

1 Answer

Unlock seat

If it's that tight it would be easier to remove the lower back seat and remove the 18 mm bolt and remove the seatbelt anchor. To remove the lower back seat pull up sharply on the front left and right sides of seat, only held in with plastic clips, then seat will pull forward and ouy

Mar 14, 2014 | Mercury Sable Cars & Trucks

1 Answer

Seat belt pasenger seat

Are you trying to say the seat belt retractor is stuck? This is in the front seat?
If it's anything like my Tahoe, you need to remove the plastic panel that covers the retractor (carefully - don't break the clips or you won't be able to put it back on). Take a large flat head screwdriver and slide it under the part where the seat belt coils up, and find a little tab - push it with the screwdriver. As long as the seat belt is not twisted up, it should retract.

Nov 30, 2011 | GMC Cars & Trucks

1 Answer

How to remove the rear seat of a Honda Ridgeline 2010.

1. Pull the plastic panels under the seat bottom straight forward to remove them.

2. Remove the six bolts (14mm) holding the seat and center seatbelt in place.

3. Pop the two small plastic covers at the top and behind the seat using a trim removal tool or screwdriver tip covered in masking tape.

4. Lift the seat straight upward.

5. Remove.

The Service Manual states a 35 ft lb torque and must be re-installed in a certain sequence for the 6 seat anchor bolts (not the seat belt bolts). When putting the rear seat back in install the bolts in this order. (1) center left (2) center right (3) left lower (4) right lower (5) left upper (6) right upper.

Nov 09, 2010 | 2008 Honda Ridgeline

2 Answers

Can I get and install seat belts?

The very best place to find seat belts at a good price is at a salvage yard. Yes you can install them yourself. They simple bolt in. Of course you have to remove some trim pieces to get to the bolts. If you want new belts then there are many places that sell them.

May 01, 2010 | 1994 Toyota Pickup

1 Answer

My drivers side seat belt is not retracting on my 2005 hyundai elantra

Most of the time this happens because the belt gets twisted behind the B pillar trim panel. The lower portion of the panel that the belt goes behind can be removed enough to see behind it by gently pulling outward, it is held in place with plastic clips. If the belt is twisted up in there, untwist it and snap the panel back in place.

Feb 06, 2010 | 2005 Hyundai Elantra

2 Answers

2005 Jeep Grand Cherokee LTD Rear Seat belt Stuck

anyone have answer for this problem??? i have 05 grand cherokee with same issue.

Aug 10, 2009 | 2005 Jeep Grand Cherokee

1 Answer

Seatbelt won't retract

1)move the plastic cover over the seat belt out of the way to gain access to the two mounting bolts for the seat belt mechanism. Use a 10mm wrench and a 14mm wrench and remove the two bolts holding the seat belt mechanism to the body. Use a small drill bit or small screwdriver and make one hole in the plastic cover on each side of the seat belt mechanism (the covers say "do not remove plastic cover". Spray lots of wd40 in each hole. Then exercise the seat belt. When the mechanism allows the belt to be retracted, retract the belt all the way out and exercise the seat belt. Reinstall mechanism with both mounting screws in original position and put plastic cover back in place. Good luck. New seat belt costs $100.00 from dealer and are hard to find working in junk yards. I have fixed several of them this way.

Jan 17, 2009 | 1996 Toyota Corolla

1 Answer

Center rear seat belt not retracting

in short;
remove rear door weather strips
remove upper c-pillar trim
remove rear deck lid cover retainer screws
remove rear deck lid trim cover
and your seat belt assembly will be right there

Jun 18, 2008 | 1998 Toyota Corolla

Not finding what you are looking for?
1994 Chevrolet S-10 Blazer Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides