Question about 2000 Ford Expedition

1 Answer

How to replace rear turn signals on 2000 expedition

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You have to open your rear door, and on the inside by your lights there are 2 screws that you have to loosen, when you loosen the screws, just pull the light cover off and you will see the bulbs that need to be replaced.

Posted on Feb 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front turn signals don't work


I'd look to see if your getting voltage if you are check your found to the front lights

Apr 21, 2014 | 2000 Ford Expedition

1 Answer

Tail light is not lighting up in my 2000 ford expedition


brake and turn are the same filament in the bulb. Try a new bulb. if that doesn't work your going to chase a short/ground on that wire back to the switch. get a wiring diagram to help.

Aug 05, 2012 | 2000 Ford Expedition

1 Answer

How can i get a wire diagram for a 2000 ford expedition 4 wheel drive turn signal switch?


Hello greeneyeblue,

Below is a diagram of the turn signal switch. I hope this helps.

netvan_114.png

Regards,
netvan

May 05, 2011 | 2000 Ford Expedition

1 Answer

Turn signal not working on 2000 ford expedition


does it blink really fast when you turn on the blinker? If so you just simply need to replace the bulb. If that doesnt fix it then you have a wiring problem, make sure all conections are secure.

Aug 03, 2010 | 2000 Ford Expedition

1 Answer

How do I access left rear turn signal to replace bulb


need to replace turn signal bulb. How to access? pulled out piece of foam out of approx. 2" hole that feed wires go thru...............

Jul 09, 2010 | 2000 Ford Expedition

2 Answers

2000 Expedition: what is a multifunctional switch on a 2000 ford ex...


This is usually the turn signal lever which also has other controls built into it.

May 17, 2010 | 2000 Ford Expedition

2 Answers

How to replace a rear turn light on a 2000 ford expedition?


how do i change a front turn signal on a 2000 expedition?

Dec 22, 2009 | 2000 Ford Expedition

1 Answer

2000 Ford Expedition-Left turn signal and brake light in rear does not work, and left front flasher works but flashes quickly. The front and rear right side of turn signal and brake works perfectly. I...


You may have some wiring 'grounding' problems in the areas of concern. Remove each connection, and clean any rust. Place a light film of grease and a fresh star washer next to ground point, then the wire connector and other washers. Tighten firmly. Check the lamp sockets for any corrosion and replace same if found. The front lamp flashes rapidly because the rear light not working causes the flasher unit to switch faster.

Oct 13, 2009 | 2000 Ford Expedition

1 Answer

Turn signal and brake lights


these vehicles have a fuse for front and back turn signals. Check the owners manual where your back tail light fuses are located. It happened in my 99 expedition four yrs ago

Jun 22, 2009 | 1997 Ford Expedition

Not finding what you are looking for?
2000 Ford Expedition Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...