Question about 2000 Pontiac Bonneville

1 Answer

How do i change low beam lamp and parking light for 2000 bonneville

2000 pontiac bonneville. Low beam lamp out, also parking light. Bought the items and don't know how to install them.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

The whole light assembly comes out in one peice. there are two bolts located on top of both ends of the assembly (silver in color)

Posted on Dec 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No low beam. Good high beam. No day lights. What's wrong?


No on the fuse . The LH HDLP and RH HDLP fuse in the fuse block - under hood, supply battery positive voltage to both low and high beam lamps at all times. For manual operation, when the headlamp switch is in the ON position, the headlamp switch supplies ground directly to the headlamps and to the body control module (BCM) on the headlamp low or high beam signal circuit, depending on the position of the headlamp dimmer switch. The BCM uses this signal to determine if the conditions are present to illuminate the daytime running lamps or park lamps.
The headlamps may be turned on 2 different ways. First, when the driver places the headlamp switch in the ON position, for manual operation. Second, with the headlamp switch placed in the OFF position activating automatic lamp control (ALC).For ALC operation, the BCM receives a signal from the ambient light sensor indicating a low or high ambient, outside, light level. Under low light conditions the BCM grounds the headlamp relay control circuit energizing the headlamp control relay. The now closed relay supplies ground through the headlamp switch to the headlamps and the BCM on the headlamp low or high beam signal circuit, depending on the position of the headlamp dimmer switch. When the BCM grounds the headlamp relay control circuit it also grounds the park lamp relay control circuit illuminating the park lamps. The headlamp relay is grounded at G203.
Daytime Running Lamps (DRL)
The low beam headlamps operate at reduced intensity when in daytime running lamps (DRL) mode. The ground circuit to the switch side of the DRL relay has a resistor in-line to reduce the intensity of the low beam headlamps for DRL operation. The body control module (BCM) receives a signal from the ambient light sensor indicating a low or high ambient, outside, light level. Under daylight conditions the BCM grounds the DRL relay control circuit energizing the DRL control relay. The now closed relay supplies ground directly to the low beam headlamps and to the BCM on the headlamp low beam signal circuit. The low beam headlamps now illuminate with reduced intensity. The DRL relay is grounded at G203. Any time the headlamps are illuminated the DRL will not illuminate. Manual park lamps do not effect DRL operation.

Feb 23, 2016 | 2005 Chevrolet Equinox LS

1 Answer

Low beams dont work replaced bulb still dont work


If both don't work check the relay if only one probably the socket

Mar 31, 2015 | 1998 Pontiac Bonneville

1 Answer

Why wont the headights or running lights work on my 2002 Buick LaSabre?


There are several reasons why your headlamps an running lights don't work , the headlamp switch is a good one ,plus relays an the DIM - dash integrated module an associated wiring ! Here is how the headlamps work , right out of Buick factory service info !
The dash integration module (DIM) provides battery positive voltage to the signal circuits of the headlamp switch. The signal circuits include the headlamp switch headlamps on signal, the flash to pass switch signal and the high beam input. With the headlamp switch in the ON position, a ground path is available for the headlamp switch headlamps on signal circuit of the DIM through the headlamp switch. The DIM provides ground to either the headlamps high beam relay control circuit or the headlamps low beam relay control circuit of the low beam circuit. The position of the headlamp dimmer switch determines which relay control circuit has ground. The DIM supplies battery positive voltage to the relay control circuits, if the headlamps are necessary. The fuse block - underhood supplies battery positive voltage to both relay switch circuits. When the low beam relay control circuit is energized, current flow is to both low beam fuses and to the low beam headlamps. The headlamps have ground at G103 and at G401. When the headlamp high beam relay control circuit is energized, current flow is to both high beam fuses and to the high beam headlamps. The high beam circuit is divided into a left and right side circuit. The current flow of the left high beam is from the fuse to the left high beam lamp. From the lamp, the current flows to the normally-closed contact of the DRL relay to G103. The current flow of the right high beam is from the fuse to the right high beam lamp. From the lamp, the current flow is to ground at G401. When the headlamp dimmer switch lever is pulled toward the driver, the flash-to-pass switch closes. This grounds the DIM flash to pass switch signal circuit. In response to this input, the DIM energizes the HDLP HI BM relay. Both high beams remain on until the driver releases the switch handle. If the low beam headlamps were on during a flash to pass operation, the low beams remain on. The headlights may be switched to high beam with the opposite movement of the headlamp dimmer switch lever.
By running lights , do you mean park lamps or day time running lamps ?
Park, Tail, License and Marker Lamps
The park lamps, including the license lamps, are turned on when the headlamp switch is placed in the PARK or ON position or anytime the headlights are requested. The fuse block - rear supplies battery positive voltage to the switch contacts of the Park LP relay. When the headlamp switch is in PARK or in ON, the park lamp switch on signal circuit of the DIM has a ground path. The DIM provides battery positive voltage to the control circuit of the Park LP relay. When the park lamps and/or the tail lamps are ON, the DIM energizes the park lamp relay control circuit. This closes the switch contacts. Current flows from the Park LP relay to the LH PARK LP and the RH PARK LP fuses. From the fuse, the current flows to the park lamps. The left park lamps are grounded at G103, G401 and G402. The right park lamps and the right tail lamps are grounded at G103 and G401. The DIMR fuse supplies battery positive voltage to the license lamps and to the DIM instrument panel lamp fuse supply voltage - 1 circuit, for interior lamps dimming. The license lamps are grounded at G401.
The best advice I can give is that you take this to a ASE certified professional repair facility unless your a qualified automotive electric repair person !
Diagnostic Starting Point - Lighting Systems
Begin the system diagnosis with the Diagnostic System Check - Lighting Systems . The Diagnostic System Check will provide the following information:
?€¢
The identification of the control modules which command the system


?€¢
The ability of the control modules to communicate through the serial data circuit


?€¢
The identification of any stored diagnostic trouble codes (DTCs) and their status

The use of the Diagnostic System Check will identify the correct procedure for diagnosing the system and where the procedure is located.

The

Mar 15, 2015 | 2002 Buick LeSabre

1 Answer

Low beams and driving lights don,t work


I'm sure a number of things can cause this problem but in my case it happened after I changed a burned out light. and even though the lamps i installed fit fine they were not the right. been a while now but I think its just a difference of a letter. hope this helps

Jan 15, 2013 | 2000 Pontiac Sunfire

1 Answer

2004 jeep grand cherokee driverside head lamp- low beam bulb needs to be replaced. How is this task performed?


That does not look like a low beam lsamp. It looks like a parking and turn signal lamp. The low and high beams are together in the main top light. To change the parking light bulb open your hood and look behind the light system for a cover over the bulbs. That should be where you can yurn out a plastic fitting that houses the bulb.

Jan 02, 2013 | Cars & Trucks

2 Answers

Low beams dont work on 2000 volvo


It can be faulty low beam lamp or its connection issue for low beam lamps.

There are few solved helps links with proper solution to troubleshoot these issues.I suggest you to refer the links below.Click the link:----
Passenger side low beam out?

http://repairhelpcenter.blogspot.com/2012/01/passenger-side-low-beam-out.html

------------
Low beam HID light goes out? http://schematicsdiagram.blogspot.com/2012/01/low-beam-hid-light-goes-out.html
----------2007 Dodge Caliber: Low Beam Headlight Not working http://technoanswers.blogspot.in/2012/06/2007-dodge-caliber-low-beam-headlight.html
-------------Chevy Tahoe: Low Beam Lamps are not working? http://technoanswers.blogspot.in/2012/04/chevy-tahoe-low-beam-lamps-are-not.html
----------2001 Chevrolet Tahoe: Both Low Beam Lamps Not Working? http://technoanswers.blogspot.in/2012/04/2001-chevrolet-tahoe-both-low-beam.html
--------------2002 Toyota Tacoma: Low Beams not working? http://technoanswers.blogspot.in/2012/04/2002-toyota-tacoma-low-beams-not.html
-----------Low beam headlights Modification? http://schematicsdiagram.blogspot.in/2012/04/low-beam-headlights-modification.html
-----------DRL and Low beams not working? http://schematicsdiagram.blogspot.in/2012/04/drl-and-low-beams-not-working.html
-----------These will help.Thanks.

Nov 25, 2012 | 2003 Volvo S80

1 Answer

No brake lights or dash lights, 2000 pontiac bonneville


Both seems related to a GROUND connection of the harness in the rear lamp assembly. It will be good to have the +12 checked in the rear lamp assembly and if there is +12 then the ground is not active to the lamp assmebly . It can be a loose joint or a fault in the harness.
You can use 12 volt park lamp as a test lamp to check with one side grounded and finding the live+12 volt.

Oct 16, 2011 | 2000 Pontiac Bonneville

1 Answer

Checked all 3 fuse boxs, fuses and lights bulbs they are good. problem is no low beams lights on both sides, only high beam and parking. any ideas? also already changed out the breaker (20-30) on the...


When you turn on your head lamp do you notice that you also have rear tail lights that are lit up as well? I have noticed on some occasion, both front headlamp assemblies could possibly be blown at the same time. One of the most important tools for checking to see if you have power on the low and high beam circuit will be a automotive test lamp, you can purchase these at most auto parts stores.

Jun 11, 2011 | 1996 Pontiac Grand Prix

1 Answer

(1996 pontiac grand am) no running or dash lights,will pop fuse right away,no sign of apparent problem!!! HELP!


Obviously there is a short circut somwhere.

Start by switching on only the park lamps.if the fuse blows you know the problem is on that curcit.

If not then switch on the low beam headlights, if the fuse blows you know the problem is on that curcit.

If not repeat this action with the hi beams.

If the fuse blows on park lamps already check the front and rear globe conectors for a short curcit. if none are found procede to check the low and hi beam globes.

Feb 14, 2011 | 1996 Pontiac Grand Prix

1 Answer

Low beam headlights not working on 2004 Pontiac Montana extended


You headlight lamp have a diffuser mechanism which allows it to flip between the hight beam and low beam feature of the bulb. In fact, you high beam will function even if the low beam is not working.

I would recommend the purchase of the new headlight lamp. It would cost you you any where from $15.00 per unit to get a replacement lamp

Dec 26, 2008 | 2004 Pontiac Montana

Not finding what you are looking for?
2000 Pontiac Bonneville Logo

Related Topics:

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...