Where is the timing belt located on 95 beretta

SOURCE: location of relays for lights

look in your fuse pannel if your light are blinking out you need to replace the switch
later paul

SOURCE: 95 chevy beretta trim outside

first take your trim off carefully and sand it down with about 80 grid sandpaper untill the whole thing is sanded. then take some primer to it wait for it to dry and the crack should have filled . put on about 3 coats of primer and then paint it back to the original color

SOURCE: need to replace tcc silonoid on a 95 beretta 3.1

the tcc solenoid is located in the tras! when u open the hood on the drivers side ! look at the trans it will be the plug thats on the bell housing ! the plug could be white or blue! the trans must be removed to replace!

Testimonial: "thanks i think. was hoping i didnt have to drop tranny "

ZJ Limited

• 17989 Answers
• Posted on Jan 10, 2011

SOURCE: Where is the computer located

For 1995 Chevrolet Beretta 2.2L SFI OHV 4cyl the Engine Control Computer is located in front seating area, passenger side, behind dash, mounted on passenger side of glove compartment cavity .

Hope this helps (remember to rate this ansrwer)

SOURCE: how do i change a

I allways recommend haveing a repair manual they can be had at an auto parts store, online in the form of a download or sometimes on ebay ina CD. That said there shoud be a belt diagram under the hood most likly on the fan shroud. You wil need to release the tension on the tensioner using a wrench to remove old belt and again to install new belt. Good luck