Question about 2003 Ford Windstar

1 Answer

2003 windstar put on new back brakes all new now the right side makes a ticking sound when you put on the brakes..any help??

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 125 Answers

This is most likely bent brake shield behind rotor check to make sure its not bent also could be brake pad clips out of place inspect for any abnormalities or even a warped rotor. My advice with brakes is usually take it to a pro but these things you could do yourself.

Posted on Feb 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Had ticking sound started up this am loud pop then rough running like there was no muffler


Ford Windstar Starting/Stalling Problems - Car Forums at Edmunds.com

forums.edmunds.com > Ford > Ford Windstar

Oct 16, 2007 - 31 posts - ‎26 authors
Learn more about Ford Windstar at the Edmunds.com Car Forums! ... I tried to startmy van on a 15 degree morning - heard a loud bang and now it won't start. Battery ....The engine will crank, start run about 5 seconds then stop. ... I have a 2003 Ford Windstar, same problem,Ford is covering up the problem.

Why My Car Won't Start? - Reasons and Solutions

www.myautorepairadvice.com/car-wont-start.html
As a rough guideline, problems with the battery, alternator and starter are the most ...Before I even put the key into the ignition I hear a clicking noise on the right side ...started it and then it started making a loud clicking noise while I was driving it ..... i have a 2003 windstar ford it was clicking and wouldn't start had to get a ...

Rough Idle Engine Dies Loud Ticking!?! Please Help! - Ford Focus ...

www.focusfanatics.com/.../103146-rough-idle-engine-dies-loud-ticking-...
Nov 6, 2006 - Rough Idle Engine Dies Loud Ticking! ... down then dies and then i restart and it has no problems but the ticking continues PLEASE HELP ME ... Level Up0% Completed ... 2. my injectors are bad and the ticking sound is one of the injectors.... Another method is to turn the AM radio on to a place where there ...Missing: windstar

Jan 08, 2016 | 2003 Ford Windstar

2 Answers

Left turn signal changes speeds when turning left and makes ticking sound in steering wheel


most of the time it is a bad bulb on that side. turn on your 4 way flashers and check front and rear of the vehicle for the one not working.

Mar 04, 2015 | 2003 Dodge Grand Caravan AWD

3 Answers

Brake Lights don't work on the back of our 2003 Ford Windstar


Did you actually check the brake light switch for power in and out ?
There are two different fuses, one for each side. And the circuit includes the turn signal switch.
The third brake light bypasses the turn signals.

Mar 01, 2013 | 2003 Ford Windstar

1 Answer

My 2003 Ford Windstar, with 131000 kms, making a rubbing noise.


check your brake pads if they are fine and if not change both of them but if fine check your brake disk if its not touching the zink plate behind it

Oct 23, 2012 | 2003 Ford Windstar

1 Answer

We had a recall 03 windstar ABS light was on all time we had front and back brakes replaced ford checked said rear axle ok but, light is still on and brakes make a terrible noise and sometimes they go to...


I own a 2001 Windstar. Your noisy brake problem could be nothing more that new brakes being broken in. I have done many brake jobs on my 2001 Windstar as well as other vehicles that I have owned. To prevent this problem from occuring, I apply a thin film of Disc Brake Quieter directly to each brake pad during the installation process. This quiets the brakes during the break in period. I hope this helps.

Jan 09, 2011 | 2003 Ford Windstar

1 Answer

Brake light, reverse light and turn signal issues


Hello. The symptoms you are describing are likely due to a poor ground. Temporarily install a new ground wire by securing a piece of copper wire to the frame with a self tapping screw. Use this ground wire along with the hot wire to see if each of these lights works. If it does, trace the ground wire back to the frame, unscrew it and clean up the metal with emery cloth so you reestablish a good ground.

Jan 28, 2010 | 2003 Ford Windstar

2 Answers

2003 windstar rear brake problem.


Take the lug bolts and try putting the broad side against the drum without the tire rim. It sounds like the rear brakes are adjusted too tight. Also check the emergency brakes which may have to be adjusted looser now that the linings are new and thicker.
If you can run the lugnuts against the drum with the broadside hitting the drum you will duplicate what is happening with the tire rim. You will be able to see better and can adjust the brakes without the tire in the way.

Sep 23, 2009 | Ford Cars & Trucks

1 Answer

Ford Windstar l998 scrubbing sound


if rotors were turned then it is just grooves in rotor

Jul 20, 2009 | 2001 Ford Focus

1 Answer

2003 windstar back brakes


replace your brake hardwares

Dec 13, 2008 | 2003 Ford Windstar

Not finding what you are looking for?
2003 Ford Windstar Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...