Question about 1996 Chrysler Town & Country

Open Question

02 crystler van: No Interior backlighting. Fuse??

My 02 Town and Country has a problem w/ the nighttime backlighting. I have no lights on the odometer(gauges and digital readout work), radio (display works), and a/c controls. Is there a fuse that controls this function? Where is it?

Posted by on

5 Suggested Answers

  • 512 Answers

SOURCE: fuse box chrysler town and country van

2002 town and country uses a relay and fuse...check fuse # 10 (a 40amp) in the box under the hood. the relay is also there

Posted on Dec 21, 2008

  • 153 Answers

SOURCE: 2001 Chrylser Town and Country Van- where are the fuses

There are two in the Power distribution center (Intelligent Power Module) near the left fender shield under the hood. Has Relays and fuses in it. It also should have a decal attached identifing the fuses and relays. Fuse #5 is the 20amp Ign on power and fuse #14 is the batt/constant power. This module is one of the On-Board computers so they call it "Intelligent". Bare in mind this is for the factory stereo, IF an aftermarket stereo has been installed there will probably be one in the harness at the back of the stereo. Let me know if this helps.

Posted on Apr 03, 2009

  • 124 Answers

SOURCE: On Chrysler Town and Country van keys were locked in the car and

does this van have factory theft device? if so you may have to reset to get the ramp working

Posted on Apr 06, 2009

  • 96 Answers

SOURCE: Town and country mini van won't atart

Can you hear the fuel pump run when you cycle the key?

Posted on Sep 18, 2009

  • 1986 Answers

SOURCE: Replacing bulbs in tail lights in a Town and Country.

  1. Open your tailgate.
  2. Look for two (2) round flat black discs about the size of a dime (but thicker) on the inside of the body (between the red lens and the weather striping).
  3. Using a pair of pliers, pull out each of these two discs.
    • Note they are in tight and may require a fair bit of force to remove.
  4. Make sure the inner part of the disc also comes out. There are two parts to this system, a grommet and a plug:
    1. Push the plug backwards through the grommet.
      • The grommet fits into the actual hole in the body, and is spread by the plug, the pressure holding them in place.
    2. Carefully remove both grommet and plug.
      • The lens assembly will fall away from the vehicle when you pull out the second grommet so be careful.
  5. Note the wiring harness that connects to a plug inside. Beside that plug are two holders for the actual bulbs.
  6. Remove the holder by pressing the sides inwards and pulling. The light socket should come out.

Posted on Oct 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Blinkers don't work at all. Where can I find the fuse or relay? I'm very frustrated. I need help.


Chris, fuse could be down under the dash to the left kind of near where your left knee would be when you are driving or under hood (engine compartment) in the fuse/relay center.
It could also be faulty flasher, wiring, etc
I will post some trouble shooting links for you.
Press the helpful button.
1996 2000 Chrysler Town and Country Interior Fuse Check 2000 Chrysler Town...

How To Install Replace Taillight and Bulb Chrysler Town Country 04 07...

Fuse Box Location in 1999 Plymouth Grand Voyager Van

Quick Tip Signs of blown IOD Fuse on Chrysler Dodge Jeep Fiat or Ram...


Feb 15, 2016 | 2002 Chrysler Town & Country

1 Answer

Need diagram for juntion box


Thread: fuse box?? - The Chrysler Minivan Fan Club Forums

forum.chryslerminivan.net/showthread.php/21174-fuse-box

Jun 26, 2011 - 10 posts - ‎3 authors
Does anyone have a diagram for the fuse box (junction box) that is inside on the drivers side for a 1998 Town and Country. I need to know what the relays are for, my manual only shows the fuses and there is ... Forum · The Minivan Mopar Garage · 3rd Generation Chrysler Minivans: 1996-2000; fuse box?Missing: juntion

Interior Fuse Box Location: 1996-2000 Chrysler Town and ...

www.carcarekiosk.com/video/2000_Chrysler_Town_and.../replace
Interior Fuse Box Location: 1996-2000 Chrysler Town and Country ... box of your 2000Chrysler Town and Country in addition to the fuse panel diagram location. ... If youneed to replace a blown fuse in your Town and Country, make sure you ...Missing: juntion

Dec 21, 2015 | 1996 Chrysler Town & Country

1 Answer

02 Town&Country LXi. A/C leaks into interior at firewall.


Sounds like the drain to the ground is stopped up.
Has anyone tried to clean it out ?

Aug 01, 2012 | 2002 Chrysler Town & Country

1 Answer

02 Town and Country Heat Controls


In the black fuse box under the hood by the battery check all fuses and use a spare relay to check the relays The fuses I would look at first are#19,20,and 24 if not it could be your BCM

Dec 12, 2011 | 2002 Chrysler Town & Country

2 Answers

2001 crystler town & country fuel pump


The Fuel pump is in the tank. The only thing I disagree with in emissionwiz post is whether to drain the tank or not. Chrysler started putting drains on the tanks in 2000 to make this easier when they went to a plastic fuel tank. I would drain the tank from the drain, disconnect the wiring then drop the tank to replace the pump. This all assumes that you verified that the fuse in the interior panel is not blown and the fuel pump relay in the power distribution box under the hood is still good.

Oct 25, 2011 | 2001 Chrysler Town & Country

1 Answer

2008 town and country wont start


02 or 08 if its an 02 and its the original battery replace the battery you received 3 extra years on your battery . if you jumped the car incorrectly there is a fuse link under the hood that blows out to protect your system. if its an 08 take your battery out and have it tested at your local auto parts store, may need a charge if this does not work i need more info
ps if your headlights come on strong with no real dimming of the interior lights battery is usually ok, if the interior lights dim or go out baterry is usually in need of charge or replacement , must see what caused that to happen, need more info

Sep 16, 2009 | 2002 Chrysler Town & Country

1 Answer

Interiour lights staying on all the time


make sure the adjustment for your dash lights is not pushed all the way to the top .

Aug 27, 2009 | 1996 Chrysler Town & Country

1 Answer

All the accessories are dead on my 1996 town & country .


this problem is caused by a defective BCM (body control module)

Apr 03, 2009 | 1996 Chrysler Town & Country

Not finding what you are looking for?
1996 Chrysler Town & Country Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...