Question about 1998 GMC Jimmy

1 Answer

1998 GMC JIMMY 4X4 NOT ENGAGING

MY 98 JIMMY STARTED ACTING UP YESTERDAY THE LIGHTS ON THE 3 BUTTONS WILL ONLY COME IN PARK, WHEN I PUT IT IN DRIVE THE LIGHTS GO OUT COMPLETELY AND CAN NOT ENGAGE THE 4X4 HI OR LOW, BUT IT HAS COME ON A COUPLE TIMES WHILE DRIVING AND HAVE PUSHED THE 4X4 AND IT WILL ENGAGE BUT KICKS OUT AND BACK TO 2HI AND LIGHT GO OUT AGAIN, ANY IDEAS

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Sounds like a vacuum line is off

Posted on Dec 13, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevrolet suburban LT 1500 LT won't disengage from four-wheel-drive


Chevrolet Suburban Questions - 4 wheel drive does not ...

www.cargurus.com > Questions > Chevrolet > Suburban

CarGurus4 wheel drive does not work - When I put the Sub in 4 wheel drive, low of high, ...Asked by Robert_Holland_073 Dec 17, 2009 at 04:06 AM about the 1994 Chevrolet Suburban K1500 4WD ... it can seize up and then the trans case may ingage but the hubs won't be locked in so it ... 1999 Chevrolet Suburban K2500 LT 4WD.

Chevrolet Tahoe Suburban 4 Wheel Drive Indicator Lights - Car ...

forums.edmunds.com > Chevrolet > Chevrolet Suburban

Oct 2, 2007 - 31 posts - ‎19 authors
My 1999 Tahoe (odo reading 137,400 miles) won't go into 4 wheel drive. .... I have a 98 suburban 1500 4x4 LT 5.7 L with 165,000 miles ... I recall once forgetting todisengage 4WD and I could feel a terrific binding when I ...
Step by Step Troubleshooting 4wd 4x4 88-98 Chevy GMC ...? 21:32https://www.youtube.com/watch?v=Su9Dkrfd_ZgJan 20, 2014 - Uploaded by rwdellingStep by Step Troubleshooting 4wd 4x4 88-98 Chevy GMC Truck. rwdelling .... Mine is acting like it is NOT pulling with the fronts,won't engage. ... Have you ever adjusted or the shift cable on your 1500 Chevy ... GM 246 transfer case, 2000 Chev Suburban- Duration: 20:09. by spelunkerd 286,045 views.GM Troubleshooting Part 13 - 4WD vacuum actuator & cable ...? 5:11https://www.youtube.com/watch?v=CbEF6PyJdU0Feb 3, 2011 - Uploaded by mr diyguy123I tacked on this video about the 4wd sys. ... I have a 1994 ChevyS10 ... My S10 won't let you go to 4 LO when your in gear. ... the front end to keep them disengaged. when you put it in 4wd, the vacuum actuator pushes a gear ...

Dec 25, 2015 | Chevrolet Cars & Trucks

1 Answer

Gmc jimmy cuts out when at stop lights and in park give it gas gos away?


98 GMC Jimmy tranny problems - YouTube

? 1:55
www.youtube.com/watch?v=oYaUfykzfG4
Oct 31, 2007 - Uploaded by mrockerrock
Fixing my transmission. ... 98 GMC Jimmy tranny problems. mrockerrock ... Never had to replace that and my 98 jimmy has 118000 miles on it.

Aug 19, 2015 | GMC Cars & Trucks

1 Answer

98 jimmy 4x4 stopped working


There is also an actuator on the front axle.

Feb 10, 2014 | 1998 GMC Jimmy

1 Answer

Code p0336 & p0339 appeared after pushing auto 4x4 on gms jimmy


Both codes indicate trouble in the CPS A circuit. In any event, the probable causes are the same:
1. Faulty sensor or solenoid

2. Connector terminal contact damaged or faulty

3. Wire harness incorrect voltage, open, short to ground or short to voltage

4. Control unit software in need of updating

5. PCM or ECM faulty

Dec 23, 2013 | 1999 GMC Jimmy

1 Answer

I have a 98 gmc jimmy the 4x4 is not working it has the push button on the dash and when you put it in 4x4 the lights work but it dont go into 4x4


Sounds like the transfer case motor is going out or bad, i know the trucks have a 4x4 engagement motor on the front differential which engages the front axles. i am not sure how yours is setup, you will have one or the other.

Dec 18, 2013 | GMC Jimmy Cars & Trucks

1 Answer

I have 95 gmc jimmy 4x4 it is still over heating after i changed theromstat


Damaged impeller on the water pump, or a leaking head gasket ?
Is the fan clutch working correctly ?

Aug 29, 2012 | 1998 GMC Jimmy

3 Answers

HOW DO I PUT A 1998 GMC JIMMY IN 4 WHEEL DRIVE?, DO I HAVE BE IN "PARK" OR CAN I CHANGE IT INTO 4 WHEEL DRIVE WHILE IM DRIVING?


You should be able to put in 4x4 while in drive less than 35mph. Mine had a switch to turn to engage or dis-engage.

Oct 15, 2009 | 1998 GMC Jimmy

2 Answers

4x4 not wprking in my 98 blazer


replace the actuater 59.00 at auto zone

Mar 06, 2009 | 1998 GMC Jimmy

1 Answer

Unable to shift from 2hi to 4hi in 1999 gmc jimmy slt 4x4


do the lights work on selector buttons if so check actuator on transfer case may be bad or replace selector switch i just did and my four wheel drive works sometimes

Dec 18, 2008 | 1999 GMC Jimmy

Not finding what you are looking for?
1998 GMC Jimmy Logo

Related Topics:

510 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

63456 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...