Question about 1997 Ford Escort

1 Answer

Where is it and how do i test wires on heater blower on 1997 ford

Need to know how to do this, please help

Posted by on

  • Anonymous Dec 16, 2008

    I have no owners manual for diagram. Blower not working. How do I check all the connecting wires? I have already checked the fuses.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Hi there, open the bonnet and bellow windscreen wippers is a black block with resistors and three electrical contacts. On my Ford Escort Estate'97 TD I disassambled and sand blast the electrical contacts in order to clean corrosion. After I did that all three blower position(speed) work as suppose to do.Hope that help.
Cheers

Posted on Dec 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the wirering to a 1997 Oldsmobile Delta 88.


what car, olds, 1988? or is it 1997
above is no clue as to car.
HVAC question,

my heater blower is dead.?
hot wire it with 12vdc battery, does the blower work now.
its good.
if the control or wires or resistor block are bad the blower will be dead.
the tests are easy with a $10 voltmeter, sold at walfart.

Jun 16, 2014 | 1997 Buick Park Avenue

2 Answers

Heater fan isn't working in my 1997 ford f150 extended cab 4x4


What have you checked so far ?
Fuse - resistor - power at the blower motor ?

Feb 13, 2013 | 1997 Ford F150 Regular Cab

1 Answer

I have a 1997 ford crown victoria. The only way the heat works is if I run a wire from the heater blower to the negative battery post. So I wanted to know what part do I need that will work the heater...


if it was me i would check all of the ground going to the blower motor it maybe a bad wire inside the motor itself and i would also look for a good used one check this website out to see if you can fine a good salvage yard near you www.junkyarddog.com also give these websites a try to see if they maybe helpful to you www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man.

Oct 15, 2010 | Ford Crown Victoria Cars & Trucks

1 Answer

Heater comes on when going over bump then it shut


Blower on High Only? This is the Blower (Fan) Motor Resistor. Was that/has been Replaced?
This should be located near the Blower Motor. Follow the wires from the Blower Motor BACK to the Resistor. Change out the Resisitor and before re-assembling back together - Check the operation.
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

Jan 20, 2010 | 1997 Ford Explorer AWD

1 Answer

Heater blower only works on high speed


You probably have a bad resistor, the resistor is located underdash on the passenger side next to the blower motor, remove the wiring harness and screws to remove it and replace it with a new one. The resistor is responsible for blower motor speeds less than full. Hope this helps, let me know.

Jan 14, 2010 | 1997 Ford Explorer AWD

1 Answer

Need to know what fuse is for blower in 2000 ford mustang 6v


I don't know how hard it would be to pull out the blower switch and test it, but to make things easier, turn the ignition to run position, or you could start the engine if you prefer, go to the passenger side engine compartment, and a few inches to the right of the blower you will see a connector that has 5 wires going to it: 2-orange/black, a light green/white, a yellow/red and a red/orange. Unplug that connector, get a wire or a jumper and ground it good somewhere to some clean metal, or the battery negative, and then touch the jumper to corresponding orange/black prong on that connector. That is the high setting on the blower, and the blower should start at full speed. If you touch any other prongs, it will go through the resistor, and the fan will start at different speeds, so that's one way to test the resistor.
If the blower works, than your switch is defective.
If nothing happens, make sure the blower fuse is good, and with a test light or a voltmeter, make sure you have power at the blower. The blower has two wires going to it, an orange/black and a brown/orange. If there is voltage on the br/o wire, and the blower didn't come on with the previous test, than the blower is defective.

Jul 21, 2009 | 2000 Ford Mustang

1 Answer

1997 ford escort, heater blower and wipers don't work


Disconnect blower motor & try another fuse....if it don't blow fuse then blower motor shorting out..

Apr 06, 2009 | 1997 Ford Escort

3 Answers

Blower doesn't blow at all, but i feel heat on 1997 ford escort


check the wire connector located under the dash on the passenger side. a poor design, it can get kicked by a passengers foot. my blower got fixed by just wiggling it a few times!

Dec 12, 2008 | 1997 Ford Escort

2 Answers

Heater only works when it wants to


could possibly be control head for heater/ac system. lots of gm vehicles have this problem.sounds like a loose connection, look under the dash on the right side near blower motor to check wires to blower motor

Nov 28, 2008 | 1997 Oldsmobile Aurora

Not finding what you are looking for?
1997 Ford Escort Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...