Question about 1993 Ford Econoline

1 Answer

Getting cold 1993 Ford E250 - Which fuse is for the blower motor?

Posted by on

  • gsobbie Dec 12, 2008

    Not sure anything has happened....just no blower.



    Suggestions for checking?

  • yadayada
    yadayada May 11, 2010

    if the blower blew a fuse then it is shorted.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 61,168 Answers

It is a 60 amp fuse in the power distribution box under the hood, if it is ok jump 12 volts to blower motor, if it runs ok then u will need to replace the blower motor speed control resistor located near the blower motor in the heater housing.

Posted on Dec 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi , I have a 2009 Ford E250 van and all of a sudden the switch that controls the blower motor doesnt activate the blower. I have heat if the vehicle is moving , but its not blowing heat from the vent


check for a good ground for the blower motor as if you have 12 volts at the motor it indicates a problem motor or no ground wire to complete the circuit

Feb 07, 2016 | Ford Cars & Trucks

1 Answer

Air quit blowing. I push the a/c button and the compressor kicks in the way it should but no air comes from the vents. No problems before. No funny noises, nothing but good hard cold air.


if blower not working at any speed disconnect the blower motor connector and put a test lit across if lit up replace blower motor this cars are well known for melting the connector at blower motor if so replace blower motor and pigtail

Aug 08, 2015 | 1993 Ford Tempo

1 Answer

Blowing fuses on blower motor 2006 e250 econoline


Both are possible.But it can be blower motor issue mostly.Its taking too load and that's blowing the fuse.How to Test and Replace Blower motor on car? http://repairhelpcenter.blogspot.com/2011/12/how-to-test-and-replace-blower-motor-on.html--------- How to Replace Blower Motor Wheel? http://repairhelpcenter.blogspot.com/2011/12/how-to-replace-blower-motor-wheel.html
----------

Also more help solutions recommended. Click the link below :---
Blower motor replacing for all vehicles? http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html
----------Blower motor Resistor shorting problem? http://schematicsdiagram.blogspot.com/2011/12/blower-motor-resistor-shorting-problem.html
--------This will help.Thanks.

Jan 25, 2012 | 2006 Ford E-250

1 Answer

1993 ford taurus blower motor dont work


check the fuses if thats not it then change the blower motor instructions below, not that hard to do!
  • Disconnect the negative battery cable.
  • Disconnect the blower motor lead connector from the wiring harness connector.
  • Remove the blower motor cooling tube from the blower motor.
  • Remove the four retaining screws.
  • Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
  • Lift up on the blower and remove it from the blower housing.
  • Installation the new blower motor by reversing the removal steps.
  • Connect the negative battery cable.
  • Dec 27, 2010 | 1993 Ford Taurus

    1 Answer

    1993 ford festiva heater blower suddenly quit. Fuse looks good. Any suggestions ?


    would look at blower motor check for power if power and dosnt work replace blower motor.

    Dec 23, 2010 | 1993 Ford Festiva

    1 Answer

    The blower motor isnot working


    First check the blower motor fuse in fuse box, if it is good check the blower motor relay by switching it around with another relay, to see if it is bad. If this does not work go to the blower control module and see if the blower is getting power, if the motor is getting power and not working, then the motor is bad, if it is not, it is more than likely the blower control module/resistor.

    Oct 04, 2010 | 1993 Chevrolet Lumina

    1 Answer

    On a 2003 Ford Econoline 3/4 ton E250, replaced resistor module and checked fuses (blower) but still have no blower function?????


    The blower is bad,or the blower switch,normaly,the blower resister only controls lower speeds,so check the switch,and the blower.

    Mar 12, 2010 | 2003 Ford E250

    1 Answer

    What's causing my 2005 E-250 blower motor not to work.


    does the motor not work at all or only on high setting? if only on high setting, i would recommend replacing the blower motor resistor. if it does not work at all, i would check the blower motor fuse first, if that has power, i would unplug the blower motor, key in run, and turn the fan on, then check for power at the blower motor connector, then check for ground, if both present, then replace the blower motor.

    Oct 24, 2009 | 2004 Ford E250

    1 Answer

    Replaced blower motor on '93 Ford Explorer, added freon, but...


    There seems to be a leakage ( of freon)somewhere in the system, you've to check it.

    Jun 26, 2009 | 1993 Ford Explorer Limited

    Not finding what you are looking for?
    1993 Ford Econoline Logo

    408 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    61037 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Fordexpert

    Level 3 Expert

    5331 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...