An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: 06 camry 2.4 engine removal
Its a front wheel drive just separate the transmission. Loosen all the bolts around the transmission bell housing and loosed the converter from the flywheel. The engine will come out and leave the tranny in the car. very easy. Good luck
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Oooh, your timing belt is OK? and the engine is hard to turn? You may have suffered an engine seizure due to oil starvation. Some Toyota Camry engines around this year suffered bad sludging, leading to this. If you take the spark plugs out, place the trans in neutral, and the engine is still hard to turn at the crank pulley, oooh, I think it is partly seized, sorry.
If not, I think the timing belt jumped a tooth or 2 (if old), or the fuel supply dropped pressure, or the spark failed at the igniter.
the trans axle is the tranny...but if you meen the c.v axles you can take off the axle nut ..then remove the tie rod and lower ball joint and change the axle shaft with out tranny removal.. the tranny is called a transaxle on a front wheel drive car cause the differential and the tranny is one unit where as on rear drive car you have the tranny and then a rear diff connected bt a drive shaft where there is 3 seprate units
First drain all fluids, remove all wiring, hoses, tie rod ends, controll arms, shafts, i recommend removing the transmission but you dont have to it just makes things easier. after all electrical and hardware has been disconnected from the engine you can put your engine hoist under the motor snug and remove the motor mounts, pull the motor out and your done. good luck
Jack up car and apply e-brake. car will roll if one of the front tires leaves the ground. remove tire , spindal nut and lower ball joint bolts. remove axle from hub then use a prybar to pop it out of trans. the passenger side will have a braket holding axle to engine , remove bolts from braket or squeeze snap-ring to rmove axle from braket.
Major job without the right tools! There are freeze plugs hidden by the bell housing on the trans. If you can see the plug without pulling the trans, use a long punch and knock the plug out(poke a hole in one edge and pry out).If you can't see the plug pull the trans. replace the plug. (you need an engine holder to hold the engine in place from the top.
You are not going to get the engine and trans out thru the top together. What I do is hold the engine with a fender supported engine hook, and I remove the transmission.
Then I pull the engine out thru the top. Hope this helps.
Thanks for choosing FixYa.
You need to remove the entire rear seat, the bottom & the seat back. Remove both of the rear inner C pillar trims, remove the rear parcel shelf, under the back window.
The speakers come UP from where they are mounted. You cannot take them out thru the trunk.
Hope this helps, and thanks for choosing FixYa.