The spring-latch popped out on the glove box

You need to replace the latch spring.Place a very small screw driver on the side of the box latch to open

unlock it as you would normally while pushing back on the locking mechanism

If the glove box was closed wrong than the latch that keeps the glove box shut will close on itself. If you take a pen or a screwdriver and put little pressure on it and try the handle again it should open. if thats not the case than replace the handle, the locking mechanism with in the handle or the spring broke or came apart.

you can go to the dealer and look at a diagram for the truk area one of the metal flange is bent that holds the tension rod in place just bend back straight i had same problem on my 2006 avalon

Get a torch and a piece of dowelling about 30cms/12ins long. screw small hook into the end of it. The spring clip nearest the centre of the car can be undone by hand. Use the flat end of the piece of dowelling to push the other clip off. you can get a hand onto the bulb housing and pull it away. change the bulb. put the housing back in place. then use the hooked end of the dowelling to pull the spring clip nearest the wing back into place, this is where the torch comes in handy. its dark in there.
secure the other clip by hand. I had three bulbs go in quick succession. I can now do this in about 10 min. It is best to replace the bulbs with original equipment. since I did that no more blown bulbs.

with a small flat head screw drive. pull the glove box latch and there will be a goldish small piece of metal behind glove box latch. remove the small gold metal piece ( you will have to break it out) and your glove box will open. the new latch will cost about 25-35 dollars. <!-- from fixya rte -->

Remove the glove box: unscrew 3 screws inside the box (in a row towards the top) and 2 on the outside (one on the bottom right side- open the car door to access it, and one on the bottom left side). Grab the bottom of the box and pull it toward you. It will come off.

Once it's off, flip it over. There are 2 screws that hold the latch housing on the box (you'll find them in the 2 circles that are cut into the plastic). Unscrew them.

Next, flip it back over to the front and stick a small flat screwdriver between the latch housing and the glove box part that it's stuck into. Gently pull the latch and the whole thing should come out.

Pop the new one in, replace the screws, put your glove box back in your car, and you're good to go!

does the latch have a keyhole? its probably locked, use you car key and put it in the keyhole turn the key it should unlock it and youll be able to open your glovebox

Needle nose plyers.
If those wont reach in far enough - you might have to remove the dipstick tube..

Not without looking at it.