Question about 1995 Ford F150 Styleside Regular Cab

1 Answer

Computer or wiring

Whin i turn off ingine ,i have to remove the battery cables, to get it to start. 1995 ford f150

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 6,674 Answers

If battery good, ( you did have it load tested right?) you probably have some kind of current draw, your not aware of. If you have a 12vdc test light, remove ,+ battery terminal & connect light between battery connection & battery. If light is on & bright, there is definately a current draw when vehicle off. A small amount of draw will be present from radio/stereo memory. Start pulling & re-installing fuses one at a time, and when light dims, or goes out, you've found the circuit causing the draw, and can now isolate it to whatever is fused on that circuit. If no luck that way, make a map of where they all go, and pull them all, and start re-installing one at a time until light comes on, to isolate

Posted on Dec 12, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove standard transmission from 1995 ford f150 ?


disconnect the battery cable then remove the drive shaft from the transmission then remove all wire and cables, then support the engine and take out all the bolts from around the toque converter then from around the transmission,then lower the transmission

Jun 27, 2014 | 1996 BMW 328i

1 Answer

Intermeting starting start sometimes then shuts off


fuel filter -- fuel pump -- fuel line plugged - ignition coil

Apr 02, 2014 | 1995 Ford F150 Styleside Regular Cab

1 Answer

Have a1995 ford f150 xtl the engine will not start jast turn.


open the hood up and then were your battery is look along the side you come to a box thats mounted on the side you see wires go to it the black box is bad,what you do is pull the wire of thr screw turn the key on take a screw driver touch the screw to the other wire it will start up if it start up the box is bad ,i just change my on my 1993 ford f150 it happen to me to ,i went a bought a new box got home change the box now my truck runs good.

Jan 25, 2011 | 1995 Ford F150 Styleside Regular Cab

1 Answer

NEED HOW TO DIAGRAM OR SCHEMATICS FOR INSTALLING NEW SWITCH ASSEMBLY TURN SIGNAL WIPER 1995 FORD F150.


Removal

  1. Disconnect battery ground cable
  1. Remove the steering column shroud
  1. Remove two self-tapping screws that attach the multi-function switch to the steering column tube casting. Disengage multi-function switch from casting.
  1. Disconnect the two electrical connectors, using caution not to damage the locking tabs. Do not damage PRNDL cable.
    raineman_15_19.gif

1
Steering Column 2
Screw 3
Multi-Function Switch 4
Wiring to Multi-Function Switch A
Tighten to 2-3 Nm
(18-27 Lb-In)


Installation

  1. Install the two switch electrical connectors to full engagement. The wiring for the switch is to be routed under the PRNDL cable.
  1. Align the mounting holes on multi-function switch with the holes in the steering column tube casting. Install two self-tapping screws making sure to start the screws in the previously tapped holes. Tighten to 2-3 Nm (18-27 lb-in).
  1. For automatic transmission (7003), verify that the PRNDL adjustment is correct.
  1. Install the steering column shroud.
  1. NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more for powertrain control module to relearn the strategy.
  2. Connect the battery ground cable.
  3. Check the steering column tube for proper operation.

I hope this helps, if you have any questions just ask

Jan 01, 2011 | 1995 Ford F150 Styleside Regular Cab

1 Answer

Have a 1995 ford f150 replaced starter selinoid and baterry win i turn engine over it clicks from selinoid on firewall oh and replaced battery cables


Do you mean that all that happens when you try to start the engine is a click from the solenoid? If so, Place a test light on the starter terminal itself and have someone try the starter. If the light comes on, but the starter doesn't run, replace the starter (probably bad brushes). Make sure the engine to frame grounding strap is intact first. Hope this helps!

May 21, 2010 | 1995 Ford F150 Styleside Regular Cab

1 Answer

1995 ford f150 won't start. battery is good. smell


Which engine is in this ? You may have dropped your timing chain

Feb 02, 2010 | 1995 Ford F150 Styleside Regular Cab

1 Answer

My 1995 ford f150 v8 302 will not start


Ford truck was running fine then it just shut's OFF, afterwards did start once stayed on for a couple of minutes then shut off again. A friend thinks it's the computer after checking the car. Note I did pressure wash the engine 2 day's before and didn't use it till now.

Nov 08, 2009 | 1995 Ford F150 Styleside Regular Cab

1 Answer

How do i replace a starter on a 1995 F150 ford pickup. Engine model 5.8L V8 FI, 315 CID


place truck on ramps or jack stands, rfmove battery cables from battery, go under truck locate starter, remove wires connected to starter, remove bolts from starter, it will fall out if not careful

Sep 16, 2009 | 1995 Ford F150 Styleside Regular Cab

1 Answer

Truck won't start something to do with Anti-Theft tried removing positive cqble to reset alarm nothing, possible wire off Anti Theft Unit Truck drove fine parked for one hour and went to leave, the en


not positive but look in owner manual for a fuel pump reset button i had this problem at one time and that fixed it it is usualy under the dash area somewhere on the drivers side or in a kick panel (decorative cover on the side firewalls inside the cab)....good luck i hope this helps!

May 04, 2009 | 1993 Ford F150 SuperCab

Not finding what you are looking for?
1995 Ford F150 Styleside Regular Cab Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...