Question about 2002 Chevrolet Cavalier Coupe

1 Answer

Installation of 02 chevy cavalier cold air intake

Is there a website with instructions on how to install just to make suer that I am doing everything right or can you supply me with them?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 15 Answers

Just make sure you hook up the vacumme line and the mass air sinsor let me know if this helps

Posted on Dec 29, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I replace a I.A.C. on a 2003 chevy cavalier

The best way to find it is go and get the new IAC Valve so you know exactly what it looks like ..While at the parts store get a small tube of die electric lube and safety glasses.make sure engine is cold...Set park brake and raise hood..Disconnect negative battery cable for safety and because if you unplug IAC Valve it will cause a dash trouble light to come on if battery is connected...So..Disconnect battery..Look at the top of the engine on or behind throttle body..You may have to remove air filter..Look around top center and you should see the valve...Carefully disconnect Valve wiring connector..Remove Valve..Inspect housing for any damage or contamination..Clean with shop towel if needed...Use lube that was purchased and lube o-ring on valve..Install valve and snug the screws tight..DO NOT OVERTIGHTEN..Lube connector terminals and reconnect wiring..Install battery negative cable that was removed ..Don't OVERTIGHTEN ..Just tight enough where you can't twist it off...Start engine and test drive.....complete..

Feb 19, 2015 | 2003 Chevrolet Cavalier

1 Answer

How to install a k&n air intake into a bravada

Go to K&n's website and download their instructions. The Bravada is the same engine as the S-10 Blazer.

Jan 28, 2013 | Cars & Trucks

1 Answer

Put K&N cold air intake in audi its not cranking over now?

make sure everything that was plugged up to the stock air cleaner and box ansd make sure everything is plugged up properly

Feb 20, 2012 | Audi A4 Cars & Trucks

1 Answer

Diagram of thermastat 2000 chevy venture

Please see my tip at . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.
  1. Remove the air cleaner intake duct.
  2. Partially drain the cooling system.
  3. Remove the radiator inlet hose from the thermostat housing.
  4. Remove the thermostat housing bolts.
  5. Remove the thermostat.
  6. Clean and inspect the thermostat housing gasket mating surfaces.

To install:
  1. Install the thermostat.
  2. Install the thermostat housing.
  3. Install the thermostat housing bolts and tighten to 18 ft. lbs. (25 Nm).
  4. Install the radiator inlet hose to the thermostat housing.
  5. Install the air cleaner intake duct.
  6. Fill the cooling system.
  7. Start the engine and check for leaks.

Oct 06, 2010 | Chevrolet Venture Cars & Trucks

1 Answer

Location of the pcv valve on a 96 chevy cavalier

it should be in the top of the intake manifold, the air cleaner tube goes into the throttle body and there is a little line that runs from the air cleaner tube into the pcv value and is screwed into the intake manifold.

Jul 31, 2009 | 1996 Chevrolet Cavalier

3 Answers

Idleing low on my chevy silverado 04

When swapping intakes you may left something unplugged or unhooked recheck the swap and connect any item left.

Jul 16, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

Cold air intake for a mazda rx7

try to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Mar 20, 2009 | 1991 Mazda RX-7

2 Answers

1998 cavalier will not start after a rain storm

classic sign for new spark plugs and wires

Mar 13, 2009 | 1998 Chevrolet Cavalier

1 Answer

Air cond. pump '02 cavalier/'91 beretta interchangeable?

as long as it is the same motor you can change everything.

Mar 03, 2009 | 2002 Chevrolet Cavalier Coupe

2 Answers

2005 Chevrolet Cavalier, No power

check air intake hose first, including MAF sensor (if dirty must clean) , then check for all other hoses for leaks and last but not least check air filter.

Feb 19, 2009 | 2005 Chevrolet Cavalier

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

544 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides