When you turn the key to start, it will start with the help of a remote starter hooked up under the hood, but you have to hold the key in the on position. If you move the key at all, the car immediately dies.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
hi make sure there is no starter kill circuit aftermarket alarm ,or remote starter if so i need the brand of the system by jumping the starter under the hood with remote start u need the ignition key to be in the run position before u crank the engine over then if it is the starter relay in the fuse box under the hood the engine will run just relace relay or check wires under the fuse box for corrosion hope it helps danny
Check the ignition switch connector. Check for 12v on the start circuit with the ignition in the start position. Check neutral safety switch connector. Check for 12v in and out of the N/S switch when the gear selector is in neutral or park and the ignition is in the start position. If you have 12v there check at the small terminal on the starter solenoid. If you find 12v there and on the big terminal there would appear to be a starter problem.
CHECK THE INSTRUMENT CLUSTER FOR POWER TO GAUGES TO SEE IF THEY WORK WHILE IGNITION IS IN THE ON POSITION.IF NO CHECK THE 40 AMP IGNITION FUSE.IF FUSE GOOD IGNITION SWITCH IS BAD OR HAS A LOOSE OR BROKEN WIRE.IF FUSE GOOD ALL GAUGES IS WORKING.I BE LOOKING AT STARTER AND STARTER SOLENOID.REMOVE THEM HAVE AUTO ZONE TEST STARTER.OR YOU CAN GET A REMOTE STARTER SWITCH AND SET OF BATTERY CABLES.HOOK BATTERY CABLES TO A BATTERY.WITH STARTER OUT OF CAR TAKE BATTERY CABLES HOOK NEGATIVE BATTERY TO STARTER BODY FOR GOOD GROUND.TAKE POSITIVE BATTERY CABLE HOOK TO STARTER POSITIVE TERMINAL WHERE POSITIVE BATTERY CABLE GOES.THEN HOOK THE REMOTE SWITCH RED WIRE TO STARTER POSITIVE TERMINAL AND THE OTHER REMOTE SWITCH WIRE TO THE S OR SWITCH TERMINAL ON STARTER SOLENOID.PRESS THE REMOTE SWITCH IS STARTER RUNS GOOD WITH NO FUNNY NOISES ITS GOOD IF STARTER DONT RUN THE STARTER SOLENOID OR STARTER IS BAD. THE PROBLEMS IN YOUR CAR COULD BE A BAD KEY TRY ANOTHER KEY YOUR CAR HAS THE THEFT DETERRENT MODULE SYSTEM BEST TO HAVE CAR SCAN TO CHECK THE THEFT SECURITY MODULE AND THE TRANSMISSION NEUTRAL SAFETY SWITCH IF ITS BAD STARTER WONT WORK.ALSO CHECK THE THEFT DETERRENT MODULE RELAY. BEFORE REMOVING BATTERY CABLES TURN OFF RADIO SO YOU WONT LOSE YOUR RADIO PLAYING CODE.
Well, it sounds like your ignition switch is bad or the remote starter you have also has an alarm with a starter immobilizer. Do you have the owners manual to your remote starter? If not you can always remove the immobilizer part of the alarm by hooking the start wire back together from the ignition switch that is cut when you hook it up.
The click you hear is the starter relay. Check for continuity thru relay with battery negative cable disconnected and switch in start position. If no continuity, it probably has burned contacts. Sometimes these can be taken apart and contacts filed/sanded cleaned.
Check the Fuel Filter and Fuel Pump. Also Check under the Hood and Look for a Fuse Relay Box. Inside this Box there should be a Relay for the Starter and Fuel Pump and Crank, Also after Replacing these Take a Flashlight and Check ALL the Fuses Really good in the Box under the Hood and the one Under the Dash on the Inside.. Replace these and let me Know how it goes.
The wire under the hood is for the hood pin switch, this wire when grounded will prevent the remote starter from starting, for trouble shooting I would leave this unhooked and make sure it is not touching any metal, also try to remote start your car with the key in the ignition swich if it remote starts you have a transponder issue if not post me and we can go from there