Question about 1995 Ford Probe

1 Answer

Serpentine belts on a 95 ford probe gt. what does each of them control?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 38 Answers

The one on left from crank going clockwise from crank is tensioner then power steering pump then water pump, then one on right from crank again clock wise is tensioner then alternator then aircon compressor, hope this helps

Posted on Dec 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Would open vacume lines cause feul smell in the cab 95 ford probe gt


no,you need to check your fuel lines and filter.











TIM.......

Oct 23, 2010 | 1994 Ford Probe

1 Answer

How to replace a timing belt gt ford probe and estamated cost


timing belt is about 35 euros and the procedure isnt difficult but again i wouldnt expect a novice to do this ,one mistake and the engine goes BANG take it to a garage .

Jul 04, 2010 | 1993 Ford Probe

1 Answer

2002 mustang GT serpentine routing


Hope this helps ya.. Cobra... :-)
f9fd01b.gif

Item Part Number Description 1 10344 Generator pulley 2 8620 Drive belt 3 8A528 Water pump pulley 4 3D673 Power steering pump pulley 5 63126 Crankshaft vibration damper 6 2E884 A/C clutch pulley 7 6B209 Drive belt tensioner 8 19A216 Belt idler pulley 9 19A216 Belt idler pulley

Jun 14, 2010 | 2002 Ford Mustang

1 Answer

I need timing belt digrams for a 94 ford probe gt has a 6 cylindar engine


moz-screenshot-1.pngAlign the engine timing marks as follows, then install the belt.

ae00695.gif

f446780.gif
Once the belt is routed, as shown below, install the indicated pulley last, then pull the pin out of the hydrualic-tensioner.
cc4ecb7.gif

May 20, 2010 | 1994 Ford Probe

1 Answer

1995 ford probe gt dohc


Try this link and scroll down until you see yours, it may be of assistance.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528003954a

Dec 12, 2008 | 1995 Ford Probe

2 Answers

1995 Ford Probe GT no spark


Hi is your Probe a 2.5cc 24valve.If it is then you may need to check the CPS(crank position sensor) All the best.Phil

Aug 17, 2008 | 1995 Ford Probe

1 Answer

Meter fuse 95 probe


you no doubt have a direct short in your wiring, or a bare hot wire is touching or rubbing a ground. check all wires that go to your meter. you don't say which meter it is. amp,water,oil,or battery.

Jun 27, 2008 | 1995 Ford Probe

1 Answer

Fuel pump relay


should be in the engine compartment fuse box and the inertia switch is located under the carpet in the rear hatch on the left side of the car

Jun 26, 2008 | 1996 Ford Probe

Not finding what you are looking for?
1995 Ford Probe Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...