It seems for me your car is overheating 200 210 is to hot and that it is why you cant crank the engin until it cools down
Ok so what would do that? Thermostat? No water n oil or oil n water..
i think you should remove the thermstate and then take it for a drive maby your thermostate dont open fully check your water hoses if the top one is hot and the bottem hose is cold their is possible that your rad is blocked call me on 0723474557
Ok I finally got a check engine light to come on and it was a code 17 replaced my crankshaft sensor now it just turns over will not start faulty sensor I'm assuming?
×
SOURCE: My 95 Taurus Sho 3.2L, stalls every day. All
Will it stall if you keep your foot on the gas like the Idle speed is set low? Possible Idle speed motor? I'll have to look up the location of the low coolant sensor.
SOURCE: My 95 Buick regal with 3.8 engine stalls while i am stopping.
Sounds like the EGR valve is bad.
SOURCE: 91 buick park avenue. Car stalls and only runs if
Might be the IAC...a good way to test this is while idling if possible, turn on the rear defroster. The rpm's should pick up. If the engine stalls at this point or the rpm's don't increase...replace it.
SOURCE: 1996 Achieva starts then stalls after 2 mins.
The only thing that you didn`t replace was the crack shaft position sensor.There are 2.One on the back of the motor and one by the crank shaft pulley.What you should do is remove the one in the back of the motor and look it over for cracks or swelling.This is the one that usually goes bad.Also you do not have to out die electric grease on this type of ICM nor do you have to do any reset for the computer.Check this out and let me know what you find.Good luck.
187 views
Usually answered in minutes!
×