How do I disconnect the battery on my car. What is the best way to do it? Its going to be -10 tonight. Is the car ok to sit with a disconnected battery till morning? I am trying to reset the check engine light that is on after I gave a boost.
An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: Hyundai Accent 2000
Hi the correct sequence for disconnecting any cars battery is always the earth lead first ! then the positive lead then to reconnect ? positive first then earth if you wish to ?? just disconnect earth lead for o/night this will be safe hope this helps ?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
HI. Here is a procedure I use to isolate a battery drain. Remove the negative battery cable from the battery. Using a 12-volt test light, hook one end to the negative battery post the other end to the negative battery cable you just disconnected. The test light will glow or "light" if there is a drain. If the "light or glow" is faint, that is probably normal draw for the clock or computer. If the "light or glow" is bright, this will indicate a large drain is present. That should be corrected,asap. Now start removing and replacing the fuses one by one until the light goes out; The one fuse that causes the light to shut off, will be the circuit with the drain. Remember to close the car doors, when testing. If not, the interior doom light will interfere with the results of the test. ..
Remove the sensor retaining screws. Remove the sensor from its mounting.
Installation is the reverse of the removal procedure.
tps is located on throttle body across from accelerator cable make sure to mark the angle with a punch or mark so when install new one it will be in the same position ' hope this helps plz vote comment or reply if need more help
Hello there: these radios the code is installed by the dealership or the manufacture of the radio so what yo can do is to either call the dealership and give them the radios information or take the car to the dealership and they can do it there for you and somtimes it yo look at your users manual the code will be in there and it will explain the steps to program it ok Hope this is very helpful for you. Best regards Michael