the engire started running hot and the heat stopped working almost immediately following. The oil and coolant were low, but not empty. Filled both and still no heat and still overheating
I have 1997 Jeep Grand Cherokee. The fuse keeps blowing. It will start and run fine until you put it...
(More)
I have 1997 Jeep Grand Cherokee. The fuse keeps blowing. It will start and run fine until you put it in gear and take your foot off the brake then it dies.Any Ideas?
just bought grand cherokee 5.2 and i now realize no front shaft going to tranfer case. i need 4x4....
(More)
just bought grand cherokee 5.2 and i now realize no front shaft going to tranfer case. i need 4x4. can the front cv joints that have ripped be the reason why the prvious owners disconnected it. and while only running in 2wheel drive,i tried to engage 4 wheel lo,while coastng at 5 t 10 mph and could not bring handle down.the manual states,you have to be movng at a lo speed while shifting.could the problem be caused by having no front shaft? i was at a standstill then, and shifted to tranny to neutrail and she did shift.no 4wheel display is on, can that be caused by no shaft?maybe a sensor is not readingor shaft has to be put in? please healp. l82work@htmail.com
My 1997 Jeep Grand Cherokee is having issues going into and out of 4wd. There is a metal ticking or...
(More)
My 1997 Jeep Grand Cherokee is having issues going into and out of 4wd. There is a metal ticking or clunking sound coming from the transfer case. We just replaced the chain and the main fork that moves the gear that puts it in 4wd about 11,000 miles ago. It sounds as if a gear is not fully engaging, but upon looking at all the teeth on all the gears, they all look good, no noticeable wear. everything looks normal, but when I engage the 4wd, it clunks and grinds, eventually going into 4wd. Once it goes into 4wd, if any substantial amount of load is applied, like pressing the brakes while giving it some gas, it still clunks and grinds.