Re: How to change windshield wiper blades on 1995...
I have this same vehicle- on the drivers side push the wiper blade away from you. and on the passanger side pull the blade towards you. the latching mechanism is similar to a U placed on its side. :) hope this helps.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Either the linkage is stripped out or broke. I would look at the spindle that the blade attaches to. On the underside of it is a linkage that must have something wrong with it. Please rate my answer so I am rewarded points for it.
the cowl grill by the front of the windshield must be removed [6 screws, three in the grill and three along the front edge] to have access to the crank arm. Remove the nut from the crank arm to detach from the wiper motor
With a pry bar screwdriver pry up at the bottom of the wiper arm & the retainer cap will come free & expose the nut that has to be removed to get the blade arm off. If it's just the wipers , with a thin flat screwdriver,you'll see an open on the blade holder,push in at this point & remove the blade. Good luck!
Remove the arms,and place them back on where they need to go,do not turn the wipers on,do this as they set now.If the wiper blades when turned on go off the left side of the windshield ,then you will have to remove everything again,and move the wipers down in the rest position,and align everything up to the rest position,with the wipers at rest,and the motor at rest.
Remove windshield wiper blades (mark the arm and stud to put back exact). The next two steps you might have to lower/raise the hood. Remove cover just below the windshield(each end has a phillips screw turn 90 degrees so arrow points toward center of van). Remove the 4 metal braces. Remove windshield wiper motor/linkage assembly(the whole tray comes out). Remove drive belt. Disconnect negative side of the battery. Remove alternator horizontal mounting bracket. Loosen vertical bracket bolts to get to electrical connectors. Finish removing bolts and alternator.
Sure pull the cover off the arm at the base(by the bottom of the windshiel) under that you will find a bolt. Unbolt the arm and pull it off then adjust both arms so that they do not entangle at the high point. You can turn on the wipers and when they reach the high end quickly shut off ignition they will stop at this position so you can adjust them, This is what we would do at the shop for about 200 bucks. Take your time and be sure to tighten everything up when you're don and you will do great. Have fun.