Indicator lights work after keeping the engine going for a while
HI i have a 1999 Hyundai Accent Auto
Just recently i am having problems with switiching on the turn signal (indicators) . I have realised that it starts workign after running the engine or drving for a considerable while . I have no idea what i should do! i couldn't even find the fuse boxes below the dash board . is it somewhere else. or do u think it is an electric problem at all??
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The two lights you mention are also two separate systems in the vehicle. There is always a code set when the Check Engine light comes on. Find an OBDII scanner & scan the ECU (Engine Control Unit) to find any codes. I need to know which code(s), there may be more than one. The Airbag light is a proprietary (Hyundai specific) system with unique coding. That particular system can only be diagnosed by a qualified Hyundai Technician and the appropriate scan device (Hi-ScanPro). Check with your nearest Hyundai Dealership... I doubt that 1999 Accent is still under warranty.
well the first thing you need to do is to pull the stored codes in the computer and see what they say and then go from there, this could be a speed sensor or a trany going bad , i dont know if this is an automatic or standard trany, start with the codes from the check engine light, autozone car parts store will scan the computer at no charge,
There are hundreds of reasons the check engine light comes on, some so simple as a loose gas cap...A good way to find out what is going on is to stop at a local auto parts store, and get them to scan your codes for free. That way you will know what caused the light, and can decide if you need to have it repaired or if it is a minor cause.
hi my name is pete glad to help code p0442is indication an evap emission <small leak > your car is ok to drive but would not pass the smog test i would advise you get a pro to sort this as the code dose not tell you where the leak is i know the canister close is located under the vehicle next to the canistertank good hunting
Usualy the check engine light reports a malfuction in your engine performance system, it coulb be a misfire, bad sensors, vaccum leak, you need to have your engine code read from a garage or an auto parts store that offers the service for free.
ok when the check engine light comes on that usually indicates a engine malfunction...what you can do is go to your local autozone and they can do an OBDII test for free..my bet says it is the cam or crank sensor.. DO NOT SHUT THE CAR OFF AT AUTOZONE..LOL
This is because there is a leak in the muffler and this light indicates increase in oxygen detected by lambda sensor... so nothing serious but you might be injecting little extra fuel causing little decrease in mileage... to fix this just replace or weld the muffler or most probably the flex pipe
I think the cause can be a poor grounding connection in engine that cause the (Oil,battery,door and hand brake lights all go on) and no check engine light because of the (ECU) not work good depending of no power in it because the poor ground ??