Question about 1994 Mazda 626

1 Answer

I can start my Mazda 626. After driving 500 meters motor stops. I have to wait about 5 minutes til I can restart. Then it works without any problem.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

I would check the coil witch is inside the Distributer. Just get a whole Distributer and change it. It could also be leads but thats unlikely.

Posted on Dec 16, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Won't restart after driving awhile

Try cleaning and resetting the throttle body 1st, if its not a dirty air or fuel filter. It might be the fuel pump but cleaning and replacing filters is a cheaper way to eliminate small problems 1st.

Apr 25, 2014 | 2001 Mazda 626

1 Answer

My mazda 626 94 5 speed stalls while driving down the road and wont restart for a few minuts. After it restarts I can make about 50 feet or up to a 1/4 mile and it will stall again, and so starts the haed...

probly needs tuneup-change plug wires and distributer cap------clean throttle body area or carb-----test fuel delivery function-pump etc------------get vehicle scanned

Jul 29, 2011 | Mazda 626 Cars & Trucks

2 Answers

I put a running engine into a 1999 mazda 626 but now the motor has no power to the starter. I put the key in and it chimes the door locks work the lights and break lights work the horn works the trunk lock...

check weather the car security system is engage or not if it is engage then the car wont start up because some times if such system is active then the car security system cut off the power supply to the starter & the engine is without power supply so better check it or the best way is to better consult a authorized Mazda service station for trouble free drive

Jun 29, 2010 | 1999 Mazda 626

1 Answer

88 Mazda 626 won't turn over

try the fusable link near tyhe battery

Aug 15, 2009 | 1988 Mazda 626 Turbo

1 Answer

Car accelerated to 4000 to 5000 rpm by itself.

could be a sensor problem in your catalytic convertor or air mass meter.

Aug 08, 2009 | 2000 Mazda 626

1 Answer

I have a 99 Mazda 626 that just quits running when you are driving down the road. Today it quit and I waited about 20 minutes and it started right up. Anyone know what could be causing this?

Try replacing the ignition switch underneath the steering collar. Pop of the top then the bottom you need a screw driver or ratchet cant remember. Its very easy to replace. I suggest buying a repair manual to see what it looks like. Very small part smaller then your hand. The part cost 100 or less with life time warranty. DO NOT BUY IT FROM THE MAZDA DEALER. They warranty their part for only 9 months? Or 30k miles.

If it starts to putter or not stay on and turn off like you describe it maybe the switch. When you install it first it may shudder or have a high rpm. I think it does this because the main computer is trying to adjust. You may have to turn it off 5 or six times or drive around the block a few times to get it to adjust. I have replaced mine twice already since I have hit 234,000k miles on it. It does burn out and my car at times will not start or turn and try to turn of while I’m driving and stop at a light with low rpms.

Jun 24, 2009 | 1999 Mazda 626

1 Answer

Car stops shifting after 5 minutes of driving?

This happends to me on a toyota camry. I got away with replacing the tranny filter and fluid. It worked but I dont know how long it will work for. chances are there is already damage done to your tranny

Jan 08, 2009 | 1997 Mazda 626

1 Answer

1991 Mazda MX-6 starts and it dies within 30 seconds or less.

Check to see fi your fuel pump is functioning, also change the fuel filter. I had this same problem on a 1984 626. While i waited for the car to restart fuel would seep into the line to allow for the enging to startbe that was it.

Dec 25, 2008 | 1989 Mazda MX-6

1 Answer

I have a mazda 626 93 when i just start it it drives perfect, but after 5 minutes driving it doesnt want to move .can u please tell me what it the problem.

Doesn't want to move as in it is still runinng and just won't go no matter how much you push on the gas, or as in it chugges and bogges and pops?????

Nov 26, 2008 | 2001 Mazda 626

4 Answers

1998 mazda 626 stalls

plugs/wires, fuel pump, fuel filter, maf, bad fuel pressure reg. depends on what it drives like, hard to answer without driving it

Jun 26, 2008 | 1988 Mazda 626 Turbo

Not finding what you are looking for?
1994 Mazda 626 Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

77947 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8832 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides