Question about 1997 Pontiac Sunfire

1 Answer

Shifter stuck in second gear

My 95 sunfire 2.4 manual is stuck in second gear, the clutch ingages fine but when you go to shift the shifter moves up or down but doesnt do anything

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 93 Answers

Your shift linkage has come undone. Jack the car up and climb underneath. You shift linkage is either com undone from the trans or you shift stabelize bad has come undone at the shift arm.

Posted on Dec 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car wont shift out of 2nd gear.the shifting handle is sloppy and the clutch is working fine


if the clutch really is working, (lever at bell moves 3/4")
by fine, my guess, is you can take off from dead stop in2nd, right>?
then its a bad shifter. tip.
or linkage (end tranny extension housing)
or transmission actual core.(shift rails, or forks) or worse.
you do know ,that you can disconnect the linkage and test tranny.
by hand,
key off
leakage off
shift to neutral (read the FSM or alldata.com) for how. under M/T sections.
then key on start engine,clutch depressed, the lift pedel
car moves its stuck in 2nd, of not bad linkage.
can do all gears that way, use 2 people and do not stand infront of car doing test.
or put the front wheels up on stands. but do not get near them.
while engine is running.
btw some shifters have plastic parts that go bad in the shifter tip.

or ,
jack up car in front, can you now shift car in to neutral or any gear?
linkage tests.
remove shifter housing and below see the shifter, H pattern
sifter box mechanism.
see that. you can shift that by hand with any small wrench or
large screwdriver, if the works the parts on the end of the shifter
handle main shaft tip are bad.

Oct 19, 2013 | 1995 Geo Prizm

1 Answer

2003 ford transit turbo manual gearbox, stuck in 2nd gear, cant start


does the clutch push normally or is the linkage broken not disengaging clutch, and then does shifter move around or locked and wont move, loose linkage in shifter or gears are jammed inside transmission and something went, if shifter wont move at all then trans is jammed inside and needs repair.

Jun 09, 2012 | Ford Transit Cars & Trucks

1 Answer

I have a Toyota Corolla AE 100 manual gear shift gets stuck


why my 2006 corolla car gearbox is stuck in third gear and cannot move

May 29, 2010 | 1991 Toyota Corolla

2 Answers

I am able to move the gear shift, but the vehicle stays stuck in reverse. When I put the gear shift in R, Drive or any other gear the car does not move or even sound like its ingaging anything.


Maybe the shifter cable. I would look under the car on the drivers side of the transmission, with the wheels blocked, have someone operator the gear shifter and see if it is moving the shift lever on the transmission.

Mar 07, 2010 | 2004 Lincoln Aviator

3 Answers

95 saturn sl 2 5 speed manual transmission, clutch pedal is fine. shifter wont go into gear


This vehicle has a pair of shift cables which attatches to the shifter and runs to the transmission shift housing.To diagnose,removal of the center console is in order so you can inspect and verify the shifter/cable connections and movement,then verify the cables move the linkages properly at the transmission . These cables are a fairly common failed part and sold as the set,these are a dealer item and no aftermarket cables are available .

Sep 10, 2009 | 1995 Saturn Sl

1 Answer

1997 pontiac sunfire manual transmission won't shift out of gear.


What you can try is to remove the shift cables from the transmission side. then move the shifter and see if everything is free if it's still sticks then the cables are going to be replaced. if everything is moving with the cable off. then you need to remove the shift tower on the tranny (where the shift cable is I belive it's 5 bolts) remove the tower and you will see the shift pin. Inside the tower there is a cotter pin that breaks and that will cause you to have one gear and unable to selected another gear. If you are not mech inclined I would no attemped the shift tower repaire, the cables do it will save you money. The shift tower has bushings that can fall into the tranny.

Jul 02, 2009 | 1997 Pontiac Sunfire

1 Answer

Grinding and very hard to shift, and now the shifter is stuck


how does the clutch pedal feel?..clutch out of adjustment,needs clutch job...kev-mn.

Dec 10, 2008 | 1995 Pontiac Sunfire

Not finding what you are looking for?
1997 Pontiac Sunfire Logo

Related Topics:

682 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...