SOURCE: 2003 santa fe 4 cycl clutch replacemnt
The fastest way is to remove the rad and move the engine ahead enough to change the clutch. Be sure to support the trans. Otherwise you will be into a lot of work under the truck. Frankster016
SOURCE: Fog Light Replacement Hyundai Santa Fe
The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.
SOURCE: how to replace timing belt in 2001 santa fe. What
I have a 2.7L v6 in my 2001 Santa Fe. It took approximately 3 hours to change the belt. One of the things you will have to do if you have the v6 is to support the engine and take off the passenger side motor mount to change the belt. Make sure you get the timing marks aligned because this is a zero tolerance engine. If you don't or if the belt breaks while the engine is running you will damage pistons and valves.
SOURCE: how to remove alternator on 2002 hyudai santa fe 4 cylinder
try these websites to see if they have your car listed www.autozone.com and the other one is www.alldatadiy.com and if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car.
SOURCE: high idle on 2002 santa fe
it sounds like a vaccum hose was inadvertently pulled off.
or the air cleaner boot has a gap somewere,
or maybe a wire connection was left undone.
hope this helps
thank you
jm
667 views
Usually answered in minutes!
×