I replaced my power steering pump in my 1994 toyota pick up and the power steering still won't work? What else could be wrong?

SOURCE: 1994 Toyota Pick up 4X4, fuel pump only works when starter is run

The information you are requesting is copy writted in order to get it leaglly go to alldatadiy.com and buy a subscription to your car and you can view all the informantion you want. and the diagram shows all the information you need includeing a powertrain harness and look up by system not in a book.

Marvin

• 85242 Answers
• Posted on Sep 03, 2008

SOURCE: toyota camry 2002 power steering

Have you thought that the new pump may not produce enough pressure, I have been involved in may repairs where a new part was the issue.

SOURCE: I'm trying to replace the power steering pump on

drain power steering fluid.disconnect the inlet and out let hoses from power steering pump.remove belt by loosen the adjusting bolts on pump bracket.remove power steering bolts and remove pump.put in new power steering pump torque it 17 ft lbs . connect hoses .put belt back on adjust the belt tension. add fluid check level . bleed the air from system.

SOURCE: what color is the power wire in 1994 toyota pick up

this might help
1994 Toyota Pickup Car Security Wiring Diagram
Battery Constant 12v+ Positive Wire (+): White And White/Red
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness
Starter Positive Wire (+): Black
Starter Positive Wire Location: Ignition Switch Harness
Ignition Positive Wire (+): Black/Yellow
Ignition Positive Wire Location: Ignition Switch Harness
Second Ignition Positive Wire (+): Black/Yellow Or Black/Red
Second Ignition Positive Wire Location: Ignition Switch Harness
Accessory Positive Wire (+): Blue/Red
Accessory Positive Wire Location: Ignition Switch Harness
Parking Light Negative Wire (-): Red/Black
Parking Light Negative Wire Location: At Steering Column Harness
Parking Light Positive Wire (+): Green
Parking Light Positive Wire Location: In Drivers Kick Panel
Power Door Lock Negative Wire (-): Blue/White
Power Door Lock Negative Wire Location: At Door Control Relay. The door control relay, is located behind the driver dash speaker.
Power Door Unlock Negative Wire (-): Blue/Yellow
Power Door Unlock Negative Wire Location: At Door Control Relay. The door control relay, is located behind the driver dash speaker.
Door Trigger Negative Wire (-): Black/White Or Black
Door Trigger Negative Wire Location: At 2-Pin Plug, Top Of Fusebox
Domelight Supervision Wire: Use Door Trigger, Requires Relay
Domelight Supervision Wire Location: N/A
Horn Negative Wire (-): Green/Red
Horn Negative Wire Location: At Steering Column Harness
Tachometer Wire Negative Wire (-): Black
Tachometer Wire Negative Wire Location: At Diagnostic Connector. The diagnostic connector, is located on the passenger inner fender near the fuse/relay box.
Brake Light Positive Wire (+): Green/White
Brake Light Positive Wire Location: At Switch Above Brake Pedal
Factory Alarm Disarm Wire (-): N/A
Factory Alarm Disarm Wire Location: N/A
Factory Anti-Theft System: N/A
Factory Anti-Theft System Location: N/A

victor mendoza

• 60 Answers
• Posted on Jun 05, 2010

SOURCE: cna i adjust athe clutch in a 1994 toyota pick-up

The linkage cable before the trans should have an adjustment nut on it. This controls the fork assembly movement. adjust the linkage to remove the pedal free play and this will also tighten the clutch.