Question about 1989 Dodge Raider

1 Answer

New water pump wont start

I replaced the water pump on a 89 raider after putting it all together it turnes over but wont fire up,what could be the problem?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Dodge Master
  • 3,433 Answers

It could be the crankshaft position sensor located near the crankshaft under you sparkling new water pump. Wires may be disconnected.:) Good Luck

Posted on Jun 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 1989 dodge raider with the 3.0l v6 that dies when I turn on the lights it has a new battery and alternator what could the issue be?


1989 raider / montero wont start need help please ' Mitsubishi 4x4 ...

www.4x4wire.com/forums/showflat.php?Number=1128085
Nov 20, 2008 - I have a 1989 dodge raider / montero the thing wont start. ... If it doeslight off, I'd suspect a fuel pump problem. Regards, Eric W. '89 Dodge Raider -- 3.0L V6, MT, SWB ... It sounds like a bad ECM if it's the V6. ... Also the truck was weird i started it up ran it for a moment and it died first thing i assumed it was ... 89' Gen I Montero rough idle/misfire and stall problems ...
Jun 28, 2011
Really rough idling and shakes ' Mitsubishi 4x4 & SUV Tech ...
Dec 20, 2010
1990 montero fuel pump fuse ' Mitsubishi 4x4 & SUV Tech ...
Jul 15, 2008
Raider won't start in this artic weather ' Mitsubishi 4x4 & SUV ...
Feb 5, 2007
More results from www.4x4wire.com

1989 Dodge Raider - Fixya

www.fixya.com/cars/t1360572-1989_dodge_raider
Jan 28, 2009 - 1989 Dodge Raider A few weeks ago, I was driving home when all of a ... I'll go back an hour or so later and it will start, warm up then die. ... I have replaced the plugs, wires, distributor, brain, basically .... If you are getting power to anything else (such as the interior light) .... 1989 Dodge Raider 3.0 L V6 EFI.

Dec 28, 2015 | Dodge Cars & Trucks

1 Answer

89 mitsubishi carby model has spark and pumps fuel to carby but the spark plugs are dry just keeps cranking but wont even try to fire also has good comp,was driving till water pump blew now just wont fire...


Check that the fuel pump is working and pumping fuel (fuse or burnt out) as it sounds like there is no fuel in the carby. To check if the engine is going to run remove the air filter from the top of the carby and pour about a table spoon of fuel directly into the carby throat. Replace the air filter and crank the engine. If is going to run it will fire and then stop

Feb 20, 2013 | Cars & Trucks

1 Answer

89 f250 overheated and stalled 3 times. I replaced thermostat and water pump. Looks like water got in my oil as ists foamy and over filled. Truck will turn over and tries to fire but wont start


Sounds like your head gasket has gone bad. you may have noticed white smoke comeing out of the exhust. do not run this engine without changeing the oil or you will destroy the engine, and if the head gasket is leaking it will dump water or antifreeze into the oil again.you can take a compression check on the engine to tell you what head gasket is bad.

Nov 24, 2010 | 1989 Ford F 250

1 Answer

91camaro 3.1 wont start


Try your ingition control mod, located on distributor. Had problem with my 89 and replaced that and fires up everytime now.

Apr 28, 2009 | 1991 Chevrolet Camaro

3 Answers

My 89 mazda 323 turns over but wont start


Last week my 323 89' Mazda stop working as I was driving it in middle of the street, I pushed to the side. it would not start, the starter sounded ok, but the car just didnt start, I checked the fuses, gas pump, and all seemed to be ok, finally with the help of a friend we found out that the ignition rotor at the distributor wasnt working we then replace it with a new one from autozone , is about 5 dollars, now it works just fine, big problem easy solution.

Victor

Dec 01, 2008 | 1989 Mazda 323

2 Answers

Bottom wheel of water pump wont turn, burning belt


The wheel could be stuck but you need to have the water drained out and a mixture of antifreeze to water added to it. Be sure to keep in mind the heater core also has fluid in it and you could damage that also.

Nov 24, 2008 | 1996 Dodge Intrepid

1 Answer

'89 Raider 3.0 Water pump


Remove the intake? No, the water pump is in front. The water pump play can cause the belt to off track.

Jun 10, 2008 | 1989 Dodge Raider

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...