Question about 1995 Honda Civic

1 Answer

1995 HONDA CIVIC HEAD GASKET

HOW CAN YOU TELL IF YOUR HEAD GASKET IS GONE

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 740 Answers

A few tell tail Signs to look for are
1. Excessive Pressure in radiator and car over heats
2. Look under oil cap when antifreeze and oil mixes it becomes a cream-ish white like heavy cream almost. It may be under there.
3. White smoke all the time out the tail pipe
4.loosing antifreeze but there is no visible leak.
5. Antifreeze in oil or oil in antifreeze.

Posted on Dec 10, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 honda civic del sol blowing black smoke


Most likely a blown head gasket or a crack in the block. Cheapest way is to find a new engine at a junk yard and have a mobile mechanic replace it.

Mar 28, 2013 | 1995 Honda Civic del sol

1 Answer

1995 honda civic d15b7 cranks but wont start. new


Are you sure you have correct timing? its definetly a fule problem, if timing is good then turn your key to the on position and try to listin for the fule pump to prime. While the key is in on position go to fuel rail, there is a valve on fule rail called sharader valve. Get a small screw driver and press valve in to check if car has fule pressure. if pressure is present then it is incorrect timing or possible bad cam sensor.

Mar 01, 2010 | 1995 Honda Civic

1 Answer

Oil leak from the head gasket on my 1993 honda civic


dear friend-i do not think the oil comes from the hear gasket but rather from the distributor,make sure that the oil is not running down onto the head gasket and the shows as a oil leak from the gasket.

Nov 09, 2009 | 1993 Honda Civic 4 Door

1 Answer

I have 1995 Civic Dx and it has been good to me till now lately my mpg has gone down alot. Usually with a full tank i can go about 400miles before filling up now its only 300-350. The engine has been tuned...


Hi
The most likely cause is the Lambda (o2) sensor failing due to contamination from the blown head gasket a simple test to check it is switching properly will tell you If a single black wire connect an A.V.O on 0-2 volts and it should switch from 0-1volt at least 20 times per minute if reads 0 its dead if reading.8/.9 it is seeing a rich mixture but the engine is not leaning it off as it should, so check your MAP sensor is clean, if your unsure take it to a professional.

Jul 10, 2009 | 1995 Honda Civic

1 Answer

98 honda civic


first ofall i wouldcheck the head gasket hasnt gone is it loosing water ,is there water in the oil white sludge

Jun 05, 2009 | 1994 Mazda 323

1 Answer

How to test head gasket (non running engine)?


Yes, remove all of the spark plugs, and test each cylinder individually. This will tell if the gasket has sealed properly. Once you get the engine running, do this again to see if it can hold combustion pressures.

Mar 26, 2009 | 1986 Honda Civic

1 Answer

HEAD GASKET


sometimes you will have antifreeze in oil...if you look at spark plugs one or more will look real clean or whiteish color... the best way to tell is do a comperssion check. all the clyinders should be the same about 180 lbs.if one is lower than rest can be a sign of a bad head gasket.... hopes this helps....

Dec 10, 2008 | 1995 Honda Civic

2 Answers

Replacing head gasket on 1995 honda civic, require torque specs and secquence


wow. a lot of bad information on this site. Refer to a manual for the proper torque sequence. The civic I believe is a two step torque procedure. First 22 ft lbs, than 53 ft lbs.

Sep 13, 2008 | 1995 Honda Civic

Not finding what you are looking for?
1995 Honda Civic Logo

Related Topics:

416 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...