Question about 2004 Dodge Sprinter

1 Answer

Dash lights turn on, but engine will not crank over

Engine lights are on, but the car will not turn over, what do i check for this?

Posted by on

  • 1 more comment 
  • vanesarock Dec 10, 2008

    the relay clicks, but nothing happens,

  • Russell Bailey May 11, 2010

    does it read start error in the cluster

  • O Mclean May 11, 2010

    Do you hear a click when you try to start?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Is it dowing any thing else any clicking or any thuing what kinda car

Posted on Dec 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Dash Lights Quit Working


Do you have the dash light dimmer control turned off by mistake? If not test the dimmer control with a volt meter.

Aug 31, 2012 | 1999 Cadillac DeVille

1 Answer

Cranks over but will not start


Look at your dash to see if the check engine light is lighting up when you turn the ignition on, before cranking. If it's not lighting up, your ecu might need to be repaired. Also, try leaving the ignition on for a while, about 30 minutes, to see if your check engine light does finally come on. The jeep should start if that light comes on. Could also be your crank sensor is bad.

Feb 22, 2011 | 1994 Jeep Grand Cherokee

1 Answer

Engine turn over but do but start no fire or spark


If no spark and you also do not hear the fuel pump prime when you turn on the ignition, then the ecu has probably gone bad and needs repair. Does your check engine light come on the dash, when you turn the ignition to on, before cranking? If not, the ecu will need to be repaired or replaced. If your check engine light comes on, then maybe it's the crank sensor that's bad.

Feb 09, 2011 | 1993 Jeep Grand Cherokee

1 Answer

1996 jeep grand cherokee 5.2L v8 is cranking but wont start doesnt look like its getting a spark


Might be your jeep's ecu is bad. Does the check engine light come on your dash, when you turn the ignition key to on, before cranking? If not, the ecu is bad. If the check engine light does come on, it may be the crank sensor is bad on your jeep.

Feb 08, 2011 | 1996 Jeep Grand Cherokee

1 Answer

My 95 jeep cherokkee wont fire i bought a new coil, rotor button and wires and a crank sensor


Might be the main part, your ecu, which is bad. Does the check engine light show up on the dash when you turn the key to on, before cranking the engine? If no check engine light on the dash, then it's the ecu that's in need of repair.

Feb 03, 2011 | 1995 Jeep Grand Cherokee

1 Answer

Won't start but engine is crank my jeep model 1993 fuel gasoline


Make sure that when you turn the ignition key on that you see the check engine light does light up on the dash, before you try cranking the engine. If no check engine light is on, the jeep won't start. If the check engine light is on and it still won't start then it could be your crank sensor, fuel pump or a host of other problems not allowing it to start.

Jan 18, 2011 | 1993 Jeep Grand Cherokee

2 Answers

When i turn the key hear a clicking sound. Lights flicker as does security light. Dash gauges move up and down no turn over at all of engine. Replaced starter,tested battery,and alternator. No starter...


try turning the engine over by hand if it will not turn sounds like seized crank bearing.grab the harmonic wheel attached to crank shaft and use that to try and turn engine,

Oct 07, 2009 | 2002 Lincoln Town Car

1 Answer

Engine won't start. Dash lights flash rapidly when key turned.


the battery says 12 volts but may be dropping to 4 or 5 under a load...i would suggest jumpstarting the car and see what happens.the battery should read in the high 12 volts and not less than 9.5 under cranking. the dash lights go out on your car when starting,and the alarm will go off ,and disable the ignition if the voltage is too low in cranking the car because the computer will shut it down and activate the anti theft.....check your battery posts are tight. best of luck

Jul 22, 2009 | 2006 Honda Accord

1 Answer

2002 Tahoe will not start


check and recheck all conections on battery and starter and grounds on battery and the ground on engine bblock and body ground or grounds,if not sure make another one ,check connections at battery ,it does sound like a bad ground to body and eng just make ur owne and see what happens

Jun 28, 2009 | 2002 Chevrolet Tahoe

2 Answers

Dash lights are not working 1999 Mercedes-Benz CLK


most probable cause could be a faulty ignition switch. Does the lights on the dash come on when you turn the key to the on position ? Do they turn off when you turn the car to the start and are about to crank the engine ? If that does not happen you will have to replace the Ignition switch. They don't have a fuse for the dash lights.

Dec 03, 2008 | 1999 Mercedes-Benz CLK

Not finding what you are looking for?
2004 Dodge Sprinter Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...