Question about 1993 Jeep Grand Cherokee

2 Answers

Fuel pump isn't coming on . bought a new one and had it tested and it works and still nothing .. checked all the fuses , all good izzybop1207@yahoo.com

Posted by on

  • turbine461 May 11, 2010

    where is fuel pump relay located

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 96 Answers

I had this problem on my 93 GC 5.2. Discovered the electrical connector near the fuel filter was loose and wet. Check the orange wire on the tail end of this connector for power when the key is cycled or when attempting to start. Or, for easier access check the orange/black wire under the rear seat, drivers side. If you have power here when the key is cycled when attempting to start, your electrical system is most likely ok.

Posted on Jan 04, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 475 Answers

Did you check the fuel pump relay?

Posted on Dec 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Microbus 2.3i four speed fuel pump not getting power


The click you hear is probably the fuel pump relay. See if you can locate it by sound. Possibly, the power feed for the pump may not be good at the relay. Pull the relay out and check for a power signal at one of the terminals that the relay plugs into. It should be a hot- at-all-times signal, so the key does not need to be on. The power feed will come from a maxi fuse in the power distribution box, or from a fusible link just off the battery. If the power is good, try another relay. If still no pump, check the wire from the relay to the pump for a short-a broken line. If wire is good, check the ground for the fuel pump.
Go back to your checking for power at the pump: just possibly, you missed the signal with the key on, because with key on the pump is only supposed to turn on for about 2 seconds (to pressurize the lines) and then shut off until the engine is cranked or running. Try testing for power again at the tank with the key held in start-should be a steady signal then, as long as the engine is cranking over. If still nothing, back to the relay. If you now have a signal for the pump when cranking engine, it must be the fuel pump ground.

Apr 07, 2014 | Volkswagen Microbus Cars & Trucks

3 Answers

Crown vic 2005 no start replaced fuel pump


check your crankshaft position sensor. fuel+spark+compression+timing=ignition.

Mar 13, 2014 | Cars & Trucks

1 Answer

Truck wont start


If you have no fuel pressure at the engine when key is on, the pump is not coming on. Check fuel pump fuse, check fuel pump relay (relay should click when key turned to on-put finger lightly on it and feel for click when someone turns key to on). If no click, signal from computer may be lost, ground for relay may be lost, or relay may be bad. If it clicks, wiring from relay to pump may have failed, or the relay's main power source may not be there at relay-find the fuse link or maxi-fuse that powers that relay. One terminal at relay should be hot at all times-can check for that with a test light.
If pump is working and you do have fuel pressure, you will need to check injector circuit. Post back if questions, or need further help.

May 25, 2013 | 1992 Dodge Dakota

1 Answer

1993 BMW NO Spark


If I had to guess your computer or a wire to it is on the fritz

Jul 17, 2012 | Cars & Trucks

1 Answer

2003 ford ranger fuel pump only has 6 volts


check your earth connections on car and to fuel pump

Oct 29, 2011 | Cars & Trucks

1 Answer

Not getting fuel; fuel pump good, filter good


If the pump isn't coming on, check the fuses, fuel pump, asd, ecm and injector. If these are good check the relay. easiest way is to swap it with another in the relay box. Also is the security light flashing?
Let me know
Randy

Apr 30, 2011 | 2002 Pontiac Grand Am

2 Answers

1994 buick park avenue . driving home and shut off


how did you jump the fuel pump relay, by bypassing the relay or by applying power to contact that closes the relay? If you bypassed the relay completely you need to b ench test the relay you can do this easily by using any 12v dc power source. If you tested the fuel pump relay by applying power to the relay and the pump run and developed pressure. I suspect a wiring or ground issue. Good luck

Oct 07, 2009 | 1997 Buick Park Avenue

1 Answer

Lost Power to Fuel pump


There is a fuel pump fuse in the fuse box, also there is a fuel pump relay under the hood in the power control box, One of these is ur problem.

Mar 06, 2009 | 1999 Oldsmobile Alero

2 Answers

Fuel Pump will not come on


check for a bad or missing ground at the pump

Aug 25, 2008 | 1999 Oldsmobile Alero

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...